116 Sending Motion Pictures as Still ImagesDuring communication a motion picture output from an external camera orVCR connected to the Communication Terminal can be frozen, and then sentto the remote party.To send a still image1 Open the Still Image menu.Press the MENU button on the Remote Commander to display the Setup menu,then select the (still image) icon with the V or v button.2 Display the picture you want to send on the monitor screen.Press the VIDEO INPUT SELECT button on the Remote Commander todisplay the Video Input Select menu, then select “AUX1” under “Near”, andpress the PUSH ENTER button.• Still images can only be sent from the device connected to the MAIN AUX INconnector.• Selecting “IR1” or “IR2” allows you to display images input from the optionalPCS-DS150/DS150P Document Stand on the monitor.• If you label “Main Camera”, “Sub Camera”, “IR1”, “IR2”, “AUX1”, or “AUX2”in Custom Input Label in the Video Setup menu, the specified name for eachcamera is displayed in the Video Input Select menu.3 Use the V, v, B or b button on the Remote Commander to select “Send”,then press the PUSH ENTER button.The motion picture on the monitor screen freezes, and a still picture is sent tothe remote party. The still picture remains even after sending.To cancel the still image display on the answering siteSelect “Clear”, or switch the input picture.Sending Motion Pictures Input from an External Camera or OtherEquipment as Still ImagesNotesTERMINAL VISCA OUT(MIXED) AUXAUX MONITORLINEAUX CONTROLMCU VIDEO OUTVIDEO OUTAUDIO OUT AUDIO INMICMAIN SUBEC-MICCTRL-SRGB OUT DSBISDN UNITIR OUT1 21 2 3 41 21 21 25DC 19.5VCAMERA CAMERAAUX IN AUX INWHITEBOARD 100BASE-TX/10BASE-T(PLUG IN POWER)to S-videooutputto videooutputS-video cable (not supplied)to MAINAUX INVideo cable (not supplied)EVI-D100 camera (not supplied)or BRC-300 camera (not supplied)VISCA cable (not supplied)VCR, etc. Video convertercable (supplied)
