7-102 Chapter 7 Session ManagementChapter 7 Session Management7-11 PreferencesSESSION TabAUTOSAVE INTERVAL• Sets the interval, from 1 to 60 minutes, between Autosaves of theworking mix. Saves will occur only if there is new data which has notbeen saved.AUTOSAVE ENABLE• Allows Autosave to be turned on or off.AUTOSAVE STATIC CHANGES• Allows Autosave to be triggered to Autosave static non-automatedchanges.CANCEL KEY CANCELS CYCLES• Allows the system to be set so that {CANCEL} on the Control Keyboardcancels machine cycle commands.The following LOCK Preferences refer to the {LOCK} push-button on the Monitorpanel in the centre section. When {LOCK} is on, a number of functions can belocked out of operation. These are useful safety settings in live and broadcastsituations where the loading of Automation and/or Snapshot data could overwritea critical console set-up.LOCK DISABLES FULL LOAD• Disables the Loading of Full console-wide Snapshots and Mixes.LOCK DISABLES PARTIAL LOADS• Disables the Loading of Partial Snapshots and Mixes which would affectless than the full console.LOCK DISABLES COPIES• Disables the Copying of settings from a source channel to one or moreother channels.LOCK DISABLES NEW LINKS• Disables the channel Link set-up mechanism but leaves channels alreadylinked intact.LOCK DISABLES MAKE STATIC• Disables the {MAKE STATIC} key on the Control Keyboard whichnormally removes automation from the working mix.LOCK DISABLES OFFLINE OPS• Disables all Offline operations whether GUI or keyboard entry.VPANEL ENABLE• Enables transport control via GPIO from an external panel or virtualpanel.Note:
