5-32 Chapter 5 Control ScreensChapter 5 Control Screens5-2 Channel ScreensGDC DISPLAY (Global Delay Compensation)Option to set what is displayed in the 8 character dot display above theGlobal Display Compensation knob on the Free Assign Area & Dynamicspanel.• ALWAYS - Units of delay are indicated continuously.• WHEN MOVING - GLOB DEL displayed until the knob is moved,when the units of delay are indicated, and remainsfor 3 seconds after release of the knob.AUTO RAISE• LEFT - EQ & Dynamics GUIs are automatically displayed inthe left channels section, above respective panels,when any EQ or Dynamics controls are adjusted.• RIGHT - EQ & Dynamics GUIs are automatically displayed inthe right channels section, above respective panels,when any EQ or Dynamics controls are adjusted.REPEAT RAISEWhen assigning I/O, clicking on the source or destination device normallycauses the pop-up to close. With the use of Repeat Raise, the pop-upremains open and increments the channel number for the same input oroutput for a further assignment and so on. Click on the red title bar at thetop left when completed.• LEFT - Repeat Raise operates for the left side of the console.• RIGHT - Repeat Raise operates for the right side of the console.RANGE• DISABLE - Disables the Range function.• ENABLE - Allows consecutive numbered sections of I/O devices,of the same type, to be assigned to consecutivenumbered sets of channels when using the I/O GUI.CAL MODERelates to the Surround LS Calibration settings for mixing to picture.• ON - LS1 Monitor Outputs use their calibration settings.• OFF - LS1 Monitor Outputs default to uncalibrated settings.SADDLE BUTTONOption to allow the buttons in the middle of the Fader Knobs to be used fortwo different functions:• PFL - Momentary PFL operation.• AUTOMATION - Fader Automation drop-in to record fader moves.FADER STARTS 1 & 2Two GPIO relay closure Fader Starts can be assigned to Channel orControl Group Faders.• Upper Button - Click on to cycle through CHANNEL and GROUPFaders or OFF.• 4 $ Buttons - Click to select the Channel or Group Fader number.
