Chapter 7 Session Management 7-21Chapter 7 Session ManagementThere are four ways to drop out of WRITE when dropping back to previous moves. The buttons for these fourmodes are on the mid right part of the panel at the base of the central LCD.1 BUTT - (default) Where a jump occurs at thedrop-out point.2 RAMP - Where a user defined time is taken toslew to the previous move. (Set the time inMIXES & CUES GUI).3 AUTO-TAKE - Where the operator manuallyfades to the previous move.4 TO END - Where the fader position at the drop-out point is recorded to the end of the Title for bothabsolute and trim functions.Central LCD Screen panel layoutThese four buttons inter-cancel but it is possible to usedifferent modes on different faders. This is achievedby working in one mode first and then rolling back touse another mode on other faders. Different modescan be used on the same fader at different times.5 TO TOP Push-ButtonA related function allowing fader position to berecorded from any point within the Title to thebeginning, for both absolute and trim. If a fader is inrecord then it is the point at which {TO TOP} is pressedwhich determines the level. If {TO TOP} is already onthen it is the point the fader is dropped into record.7-5-7 Dropping Out of Write on Subsequent Mix PassesAUTOTAKETOUCHWRITESELECTTOUCHHOLDTOUCHCLEARTOENDBUTT RAMPREADYABSOLUTEREADYTRIMREADYCANCEL1 23 4ISOLONAUTOISOLAUTOISOLCANCELAUD-ITIONTOTOPROLLBACKJOINAUTOOFF5
