Sony Betacam SX DNW-A65 Operation Manual

Also see for Betacam SX DNW-A65: Specifications

Contents

WARNINGTo prevent fire or shock hazard, do notexpose the unit to rain or moisture.To avoid electrical shock, do not openthe cabinet. Refer servicing to qualifiedpersonnel only.This apparatus must be earthed.WARNING: THIS WARNING IS APPLICABLE FOR USAONLY.If used in USA, use the UL LISTED powercord specified below.DO NOT USE ANY OTHER POWER CORD.Plug Cap Parallel blade with ground pin(NEMA 5-15P Configuration)Cord Type SJT, three 16 or 18 AWGwiresLength Less than 2.5 m (8 ft 3 in)Rating Minimum 10 A, 125 VUsing this unit at a voltage other than 120Vmay require the use of a different line cord orattachment plug, or both. To reduce the riskof fire or electric shock, refer servicing toqualified service personnel.This symbol is intended to alert the user tothe presence of important operating andmaintenance (servicing) instructions in theliterature accompanying the appliance.For the customers in the USAThis equipment has been tested and found to comply withthe limits for a Class A digital device, pursuant to Part 15 ofthe FCC Rules. These limits are designed to providereasonable protection against harmful interference whenthe equipment is operated in a commercial environment.This equipment generates, uses, and can radiate radiofrequency energy and, if not installed and used inaccordance with the instruction manual, may cause harmfulinterference to radio communications. Operation of thisequipment in a residential area is likely to cause harmfulinterference in which case the user will be required tocorrect the interference at his own expense.You are cautioned that any changes or modifications notexpressly approved in this manual could void your authorityto operate this equipment.The shielded interface cable recommended in this manualmust be used with this equipment in order to comply withthe limits for a digital device pursuant to Subpart B of Part15 of FCC Rules.For the customers in EuropeThis product with the CE marking complies with both theEMC Directive (89/336/EEC) and the Low Voltage Directive(73/23/EEC) issued by the Commission of the EuropeanCommunity.Compliance with these directives implies conformity to thefollowing European standards:EN60065: Product SafetyEN55103-1: Electromagnetic Interference (Emission)EN55103-2: Electromagnetic Susceptibility (Immunity)This product is intended for use in the followingElectromagnetic Environment (s):E1 (Residential), E2 (Commercial and light industrial), E3(Urban outdoors) and E4 (Controlled EMC environmentex. TV studio)Pour les clients européensCe produit portant la marque CE est conforme à la fois à laDirective sur la compatibilité électromagnétique (EMC) (89/336/CEE) et à la Directive sur les basses tensions (73/23/CEE) émises par la Commission de la Communautéeuropéenne.La conformité à ces directives implique la conformité auxnormes européennes suivantes:• EN60065: Sécurité des produits• EN55103-1: Interférences électromagnétiques (émission)• EN55103-2: Sensibilité électromagnétique (immunité)Ce produit est prévu pour être utilisé dans lesenvironnements électromagnétiques suivants:E1 (résidentiel), E2 (commercial et industrie légère), E3(urbain extérieur) et E4 (environnement EMC contrôlé ex.studio de télévision).Für Kunden in EuropaDieses Produkt besitzt die CE-Kennzeichnung und erfülltsowohl die EMV-Direktive (89/336/EEC) als auch dieDirektive Niederspannung (73/23/EEC) der EG-Kommission.Die Erfüllung dieser Direktiven bedeutet Konformität für diefolgenden Europäischen Normen:• EN60065: Produktsicherheit• EN55103-1: Elektromagnetische Interferenz (Emission)• EN55103-2: Elektromagnetische Empfindlichkeit(Immunität)Dieses Produkt ist für den Einsatz unter folgendenelektromagnetischen Bedingungen ausgelegt:E1 (Wohnbereich), E2 (kommerzieller und in beschränktemMaße industrieller Bereich), E3 (Stadtbereich im Freien)und E4 (kontrollierter EMV-Bereich, z.B. Fernsehstudio)