131Settings and Adjustmentsb Notes• When picture noise appears after you change the“Screen Resolution” setting, hold down x (stop)on the recorder, and press Z (open/close) on therecorder.• When “Colour” is set to “YCbCr 4:2:2” in the“HDMI Output” setup, you cannot select “720 x576i” (or “720 x 480i”).This setting is effective only when you set“TV Type” to “16:9” in the “Playback”setup.Adjust this setting to watch 4:3 aspect ratiosignals. If you can change the aspect ratio onyour TV, change the setting on your TV, notthis recorder.Note that this setting is effective only forHDMI connection.Selects the method of outputting videosignals for the HDMI jack.b Notes• Some settings may not be available dependingon the connected device.• When a DVI device is connected, you cannotselect “YCbCr 4:2:2” or “YCbCr 4:4:4.”• When “Screen Resolution” is set to “720 x 576i”(or “720 x 480i”) in the “HDMI Output” setup,you cannot select “YCbCr 4:2:2.”Selects the type of audio signal output fromthe HDMI OUT jack.b Notes• The PCM signals may not be output even whenyou select “Auto” depending on the “Audio Out”settings, number of audio channels, and theHDMI-connected device.• The “Audio Output” function is not availablewhen a DVI device is connected.4:3 Video OutputFull Select this when you canchange the aspect ratio onyour TV.Normal Select this when youcannot change the aspectratio on your TV. Shows a4:3 size video with theaspect ratio as it is.ColourRGB (0-255) Outputs RGB (0-255)signals. Select this whenconnecting to an RGB (0-255) device.RGB (16-235) Outputs RGB (16-235)signals. Select this ifcolours appear overlyrich and the blackappears too deep.16:9 aspect ratio TVYCbCr 4:2:2 Outputs 10-bit YCbCr4:2:2 component signals.YCbCr 4:4:4 Outputs 8-bit YCbCr4:4:4 component signals.Audio OutputAuto Outputs Dolby Digital,MPEG and DTS audiosignals as a bitstreamsignal. Normally selectthis position.PCM Converts all audiosignals except for DTSsignals to PCM.BitstreamPrioritySelect this if theconnected device iscompatible withbitstream audio.Control for HDMIOn Allows you to use the“Control for HDMI”function (page 20).Off Turns off the function.
