122Video Settings (Video In/Out)You can adjust items related to the image,such as size and colour, according to the typeof TV, tuner, or decoder connected to therecorder.Selects the colour system when picture noiseappears after you change the “Input LineSystem” setting (page 118).z HintWhen “Input Line System” is set to “NTSC,” youcan select “Auto,” “3.58NTSC,” or “PAL-60.”Selects the signal format in which therecorder outputs video signals: interlace orprogressive, from the COMPONENTVIDEO OUT jacks.b Notes• When you set “LINE 3 Out” to “RGB,” youcannot set “Component Video Out.”• When you connect the recorder to a monitor orprojector via only the COMPONENT VIDEOOUT jacks, do not set “LINE 3 Out” to “RGB.”If you set “LINE 3 Out” to “RGB,” in this case,the picture may not appear.• When picture noise appears after you set therecorder to progressive format, hold down x(stop) on the recorder, and press Z (open/close)on the recorder.• No video signals are output when using theHDMI connection.Selects a method of outputting video signalsfor the LINE 3 – TV jack.b Notes• If your TV does not accept S-video or RGBsignals, the image will not be displayed in theselected method on the TV screen even if youselect “S-Video” or “RGB.” Refer to theinstructions supplied with your TV.• SMARTLINK is available only when “Video” isselected.• RGB signals are not output when using theHDMI connection.Input Colour SystemAuto Recorder automaticallydetects signals of coloursystems and selects theappropriate colour system.PAL Selects the PAL coloursystem when “Input LineSystem” is set to “PAL/SECAM.”SECAM Selects the SECAM coloursystem when “Input LineSystem” is set to “PAL/SECAM.”Component Video OutNormal(Inter-lace)Outputs signals in theinterlace format.Progressive Outputs signals in theprogressive format. Selectthis when you want to viewprogressive signals.LINE 3 OutVideo Outputs video signals.S-Video Outputs S-video signals.RGB Outputs RGB signals.
