2 Machine information 03/20132.2 Variable monitors – time Series – measurements and measurement series© Siemens AG 2006-2013 All Rights Reserved2-46 SINUMERIK Integrate AMB, AMC, AMM, Function Manual (FH) - 03/20132.2.3 Control elements of the diagrams for individual measurementsFig. 2-26: Header line for individual measurement diagramSelecting the characteristicThe drop-down list box contains the list of characteristics that are available for eachtype of test. If you click a name of the characteristic, then the characteristic that hasbeen displayed up until this point is replaced by the new one.New characteristic in a separate diagramIf you click the "Display in new diagram" button on the right-hand side next to thedrop-down list box of characteristics, a new diagram of the same type will bedisplayed below the diagram that is already shown.The new diagram adopts all display characteristics of the original diagram (marks,zoom, etc.).Where individual measurement diagrams are concerned, the "Actions" menu andcontext menu have the same options:Function DescriptionParameters Shows the pop-up window with the list of measurementparameters. The same pop-up window can be openedfrom the context of the time series.General conditions Shows the pop-up window with the list of measurementparameters.Comment Pop-up with measurement comment.Scaling Selection of the diagram scale (only for the equabilitytest). In the case of the diagrams for the circularity testand universal axis test, the "Actions" menu does notcontain "Scaling".Scaling for the equability testFig. 2-27: Scaling for the equability test
