Samsung iDCS500 User Manual

Also see for iDCS500: Programming manual General description User guide User guide Manual

Contents

Samsung iDCS500 iDCS Keyset User Guide– 10 –OUTSIDE CALLSMAKING AN OUTSIDE CALL1. Lift the handset and press an idle outside line key, line group key or diala line access code to receive dial tone.ORTo use the speakerphone, press an idle outside line key or line groupkey, or dial a line access code, to receive dial tone through the speaker.ORPress the Speaker key, receive internal dial tone and dial a line accesscode.2. Dial the telephone number.3. Finish the call by replacing the handset or pressing the ANS/RLS key.Note: You will receive No More Calls tone if you attempt to make a call and there isno Call key programmed.ß If Least Cost Routing (LCR) is enabled on your phone system, there maybe a key labelled LCR or it may be selected by dialling the access code(e.g. ‘9’) which is set during system installation.ß If your system is programmed to require an authorisation code before youcan make a call, dial › plus a valid code before selecting a C.O. line.ß If your system is programmed to require an account code before you canmake a call, press the ACCT key or ACCT soft key, or dial 47, followedby a valid account code. Press the ACCT key again (or the ACCT softkey) and then select a C.O line.For more information on authorisation and account codes, see your systemadministrator.Note: If the Hot Keypad feature has been turned off, you must first lift the handsetor press the Speaker key before dialling.