CHAPTER 5. Maintenance OfficeServ 500 Wireless LAN Service Manual/Ed.00Page 5-10 © SAMSUNG Electronics Co., Ltd.2 Upgrading the WBS24 S/WWBS24 S/W is upgraded in the following two methods.y Use the web browser screeny Use the network bootingIt is recommended to use the web browser method that the setting is easy and theusage is simple.When the WBS24 generates a fault due to the flash memory that is notfunctioning(When all the 5 LEDs of the WBS24 blink, except the PWR LED), theWBS24 can be recovered/upgraded using the network booting method.2.1 Upgrading via the Web BrowserThe method of using the web screen is different according to what types of theWBS24 connection is made, whether by wire or by wireless. Each type is describedin the following section.2.1.1 Wireless ConnectionPreparing Materialsy PC(PC or laptop computer is recommended) that is loaded with the WLANNIC(Network Interface Card) card.y Upgrade file for HTTP(tar type)Upgrade Procedure1) After placing the PC within about 10M from the WBS24, bring up the webbrowser by connecting the IP address of the WBS24 wirelessly. The IP addressof the WBS24 is set from the system, and the established value can be inquiredthrough the MMC 845. Verify if the DASL status is ‘Active(Config OK)’ on theconnected web screen. If the status is not ‘Active(Config OK)’ after reloadingthe web screen, wait for the active status.
