OfficeServ 500 Wireless LAN Service Manual/Ed.00 CHAPTER 4. MMC Programming© SAMSUNG Electronics Co., Ltd. Page 4-172.7 Setting the MMC831 MGI ParametersThis MMC provides a mean to configure the Internet Protocol(IP) addressing of theMGI card(s). This MMC must be utilized MGI card(s) used on the system.Table 4.4 MMC831 ParametersNumber Parameters Description0 IP ADDRESS Specifies the IP address for the MGI card.1 GATEWAY Specifies the designated IP gateway address used for contacting IPdevices beyond the local subnet.2 SUB MASK Specifies the IP subnet mask. This parameter is used by the system tocalculate the range if IP devices(subnet) that are within ‘direct reach’of the MGI(without having to go through the designated network IPgateway).3 PUBLIC IP The MGI will originate communications, to IP phones and VoIPconnections outside the local network, using this IP address. If thisIP address sets 0.0.0.0, 255.255.255.255 or default value then thisMGI card uses private IP only. See System IP Type on MMC 830.4 STS PERIOD No entry required. Designates the timed message cycle to check theremote IP status of MGI3 S/W.5 VERSION No entry required. Used to indicate revision of MGI3 S/W.6 MAC ADDR For your reference, and cannot be changed. The uniquehardware(MAC)address of the MGI card.7 CARD RESET Prompt to restart MGI card when IP address is changed. This usefor MGI 1 and 2 only, MGI3 is self restart automatically.A MGI cardThis MMC cannot be accessed unless there is a MGI card installed in the system.Program ButtonsVOLUME Used to scroll through optionsKEYPAD Used to enter selectionsSOFT BUTTONS Move cursor left and rightSPEAKER Used to advance next MMC
