CHAPTER 3. Installation OfficeServ 500 Wireless LAN Service Manual/Ed.00Page 3-12 © SAMSUNG Electronics Co., Ltd.6 Registering/Clearing the WIP-5000M TerminalThe WIP500M terminal must be registered to the system to be used in the OfficeServ500 System Wireless LAN. This section introduces the procedures for registering andclearing the register of a terminal.6.1 Registering a WIP-5000MRegister a WIP-5000M terminal following the instructions below.1) Confirm if the system DB items are set according to the ‘Setting the System DB’section of this chapter.2) Register the WIP-5000M terminal at the register menu.Refer to the ‘WIP-5000M User Manual’ for the register procedure.3) The Network ID shall be entered correctly during the WIP-5000M registerprocedure. Especially, the User ID and Password shall be identical to that of thesystem. If an error occurs during execution of register procedure, check thesystem DB settings and repeat the procedure above.4) An extension number will be assigned to the WIP-5000M upon completion ofthe terminal register.6.2 Clearing a WIP-5000MWhere theft or breakage of a WIP500M Station causes a new terminal to beregistered, registration of the previous terminal shall be deleted.The clearing procedure for the WIP-5000M is described below.Clearing from the SystemTo clear the WIP500M in use, which is within the wireless LAN service area, set thenormal mode through the system MMC.If the terminal is not within the service area or is not in use, delete the terminal’sregistration DB in the system using the forced mode through the MMC system.Clearing from the WIP-5000MThe terminal’s registration DB may be deleted from the WIP500M within thewireless LAN service area. Refer to the ‘WIP500M User Manual’ for terminationprocedure in detail.
