Samsung MIM-E03EN User Manual

Also see for MWR-WW10N: Installation manual User manual Installation manual Service manual

51EnglishField Setting Mode࡙ 4012 : The temperature of forced heating priority (Refer to 4011)࡙4013 : If the ambient temperature > 4013, Heating Mode stops in auto mode.࡙ Code 50** ࣕUser’s options for extra functions501*: New target temperatures of each mode (Heating/Cooling/DHW) when "Outing" function is on࡙ 5011: Value of cooling leaving water temperature setting when "Outing" function is on࡙ 5012: Value of cooling indoor’s room temperature setting when"Outing" function is on࡙ 5013: Value of heating leaving water temperature setting when "Outing" function is on࡙ 5014: Value of heating indoor’s room temperature setting when"Outing" function is on࡙ 5017: Value of Water Law’s floor control (#2041=1) leaving water temperature setting when "Outing"function is on࡙ ࡠߩߢߡߦǤɇ̷Їʪͱ˙Ǯɇϩʪθøɇи࣭ϑAƸʀͱ͝ϩθͱ̷࣍ߢߥߡߣࢄॉߣ̷࣎ʪɇӬ͝˝иɇϩʪ θϩʪ͔ΧʪθɇϩЇθʪϑʪϩϩ̈͝˝и˵ʪ͝ĮЇϩ̈͝˝function is on࡙ 5019: Value of DHW tank’s temperature setting5021: Offset temperature setting when Economic DHW operation is on (During Economic DHWoperation, temperature will be automatically set lower by value of #5021(°C) than actual setting)504*: Smart Grid control࡙ 5041: Application of Smart Grid control࡙ 5042: Heater application during Smart Grid control ࣕ0: Heater off during Smart Grid control ࣕ1: Heater control during Smart Grid control ࣕ2: Not use࡙ 5043: Input Voltage from Smart Grid contact port ࣕ0: If Smart Grid Voltage = 0V, Smart Grid Control is Operated ࣕ1: If Smart Grid Voltage = 5V, Smart Grid Control is Operated࡙ 5061: Water supply capacity ratio compared to heating: The load of hot water tank if designedheating (floor or Fan coil unit) load is 7ex) When required heating load is 14000W, required hot water tank load 10000W, 10000/14000x7= Set 5