Samson Resolv 120a Owner's Manual

Also see for 120A: Product specification sheet Owner's manual Owner's manual

Contents

Samson Resolv 120a Owner's Manual Manual pdf 16 page image

16�� OUTPUTCHANNEL 1CHANNEL 2MINIMUM LOAD IMPEDANCESTEREO(4/CHANNEL)BRIDGED MONO(8)+- + -+-�� CAUTION ; REPLACE WITH THE SAME TYPE FUSE AS INDICATED.UTILISER UN FUSIBLE DE RECHANGE DE MEME TYPE.www.samsontech.comCHANNEL 1TIP RING SLEEVETIP +RING -SLEEVE GNDCHANNEL 2TIP RING SLEEVETIP +RING -SLEEVE GNDINPUTSBRIDGED STEREOMODE SELECTOR(10K / 0dBu)INPUT (10K / 0dBu)INPUT20A / 250VPUSH TO RESET~AC INPUT115V / 60Hz, 800WSERIAL NUMBER��INPUT– +INPUT– +��Connecting the RESOLV 120aStereo Sub With Passive SatellitesTwo RESOLV 120a’s can be used with any pair of passive or active monitors. Below is a typical system set-up using twoRESOLV 120a’s with a mixer, stereo power amp and a pair of passive satellite loud speakers. The RESOLV 120a’s inputsand outputs utilize industry standard RCA connectors. For a detailed wiring diagram, see the section “ RESOLV 120aConnections” on page 19. Follow the steps in the diagram below to set up your system.• Lower your mixer’s master outputs to all the way off.• Connect the mixer’s left output to the left side RESOLV 120a’s LEFT PREAMP INPUT and the mixer’s right outputto the right side RESOLV 120a’s RIGHT PREAMP LEVEL INPUT. Now connect the left RESOLV 120a’s LEFT PREAMPOUTPUT to the left side input of the power amp, and the right RESOLV 120a’s RIGHT PREAMP LEVEL OUTPUT to theright side input of the power amp. Connect a speaker wire from the left output of your power amp to your left satel-lite, and then, connect a speaker wire from the right output of your power amp to your right satellite.• Now adjust the SWEEP control to the desired frequency. Consult your studio monitors owner’s manual for a recom-mended crossover point. You can also use your ears by adjusting the SWEEP control to the frequency that soundsgood to you. A good place to start is about 70 Hz.• Now set the level of your power amp up to the normal operating level. Run an audio signal (like some music froma CD) through your mixer and raise the level to a comfortable listening level. Now slowly raise the RESOLV 120aVolume control and listen to the low frequency output. Adjust the RESOLV 120a to the level of low frequency outputthat you like. Now, when you raise and lower your mixer’s output, the RESOLV 120a and satellites will track at thesame relative volume.ENGLISH