Samson Resolv 120a Owner's Manual

Also see for 120A: Product specification sheet Owner's manual Owner's manual

Contents

Samson Resolv 120a Owner's Manual Manual pdf 14 page image

14Connecting the RESOLV 120a�� OUTPUTCHANNEL 1CHANNEL 2MINIMUM LOAD IMPEDANCESTEREO(4/CHANNEL)BRIDGED MONO(8)+- + -+-�� CAUTION ; REPLACE WITH THE SAME TYPE FUSE AS INDICATED.UTILISER UN FUSIBLE DE RECHANGE DE MEME TYPE.www.samsontech.comCHANNEL 1TIP RING SLEEVETIP +RING -SLEEVE GNDCHANNEL 2TIP RING SLEEVETIP +RING -SLEEVE GNDINPUTSBRIDGED STEREOMODE SELECTOR(10K / 0dBu)INPUT (10K / 0dBu)INPUT20A / 250VPUSH TO RESET~AC INPUT115V / 60Hz, 800WSERIAL NUMBERMADE IN KOREA��INPUT– +INPUT– +• Lower your mixer’s master outputs to all the way off.• Connect the mixer’s left output to the RESOLV 120a’s LEFT PREAMP LEVEL INPUT and the mixer’s right output to theRESOLV 120a’s RIGHT PREAMP LEVEL INPUT. Now connect the RESOLV 120a’s LEFT PREAMP LEVEL OUTPUT to theleft side input of the power amp, and the RESOLV 120a’s RIGHT PREAMP LEVEL OUTPUT to the right side input of thepower amp. Connect a speaker wire from the left output of your power amp to your left satellite, and then, connect aspeaker wire from the right output of your power amp to your right satellite.• Now adjust the SWEEP control to the desired frequency. Consult your studio monitors owner’s manual for a recom-mended crossover point. You can also use your ears by adjusting the SWEEP control to the frequency that soundsgood to you. A good place to start is about 70 Hz.• Now set the level of your power amp up to the normal operating level. Run an audio signal (like some music from aCD) through your mixer and raise the level to a comfortable listening level. Now slowly raise the RESOLV 120a vol-ume control and listen to the low frequency output. Adjust the RESOLV 120a to the level of low frequency outputthat you like. Now, when you raise and lower your mixer’s output, the RESOLV 120a and satellites will track at thesame relative volume.Mono Sub With Passive Satellites Using Line InputsThe RESOLV 120a can be operated using line level inputs and outputs. When using the RESOLV 120a at line level, the fullrange signal is maintained at the outputs. Below is a typical system set-up using the RESOLV 120a with a mixer, stereopower amp and a pair of passive satellite loudspeakers. The RESOLV 120a’s inputs and outputs utilize industry standardRCA connectors. For a detailed wiring diagram, see the section “RESOLV 120a Connections” on page 17. Follow the stepsin the diagram below to set up your system.ENGLISH