7–iSCSI Noninteractive Commands-nc (Display Neighbor Cache [IPv6])SN0054667-00 G 7-17-nc (Display Neighbor Cache [IPv6])To display the neighbor cache (IPv6 only), issue the -nc command as follows:-nc <hba_port_inst>-netconf (Configure IPv6 Settings)To configure the network settings, issue the -netconf command as follows:-netconf <hba_port_inst> [-IP <IP address>] [-IPNM <subnet mask>][-IPGW <gateway IP address>]Where:iSCSI_Snack ISNACK on or offiSCSI_Strict_Login IS on or offTCP OptionsTCP_Auto_Discovery SLPADIS on or offTCP_DHCP TCPDHCP on or offTCP_Nagle TCPN on or offTCPMaxWindowSize TCPMWS 1000h–FFFFhTCP_Time_Stamp TCPTMS on or offMiscellaneous OptionsKeepAliveTO KATO 0–65535Large_Frames LRGFRM on or off aMaxBurstLen MBL 0–65535MaxOutstandingR2T MOR2T 0–65535a Not for QLA4010IP <IP address> = Set the IP address of the adapterIPNM <subnet mask> = Set the subnet mask of the adapter-IPGW <gateway address> = Set the gateway-DISN4 = Disable IPv4 network setup-IPv4DHCP = Set DHCP onTable 7-3. Adapter Parameters (Continued)Configuration NameConfiguration AliasValue
