6–Fibre Channel Noninteractive Commands-vSN0054667-00 G 6-39To update the adapter firmware preload table, issue the following command:# qaucli -pr fc -u ( <hba instance> | <hba wwpn> ) <file name>To save the current adapter firmware preload table to a DAT file, issue thefollowing command:# qaucli -pr fc -u ( <hba instance> | <hba wwpn> ) save <file name>Where: <hba instance> is the adapter instance number of an adapter port. <hba wwpn> is the world wide port name of an adapter port. <file name> is the name of the firmware preload table DAT file.-vTo show the version number of the QConvergeConsole CLI utility, issue the -vcommand as follows:# qaucli -pr fc -vThe system shows the following information:QConvergeConsole CLIv1.x.x Build xCopyright 2003-2009 QLogic Corp.All rights reserved.Command Line QLogic FC Host Bus Adapters.Build Type: ReleaseBuild Date: xx/xx/xxxx xx:xx:xx AM-vp (Virtual Ports [NPIV])To list all virtual ports on a physical adapter port, issue the -vp command asfollows:# qaucli -pr fc -vp (<hba instance> : <hba wwpn>) list allWhere:NOTEThe -v option is valid only in noninteractive mode.hba instance = Adapter number (use the -g command to find)hba wwpn = World wide port name of the adaptervport wwpn = World wide port name of the virtual portvport hex = World wide port name of the virtual port with the twohexadecimal digits in byte three supplied by the user
