6–Fibre Channel Noninteractive Commands-n (Configure HBA Parameters)SN0054667-00 G 6-27To disable (deselect) all LUNs for a specific target on a specific adapter, issue thefollowing command:# qaucli -pr fc -m (<hba instance> | <hba wwpn>) deselect | disable<target wwnn> <target wwpn>To enable (select) all LUNs of all targets on a specific adapter:# qaucli -pr fc -m (<hba instance> | <hba wwpn>) select allTo disable (deselect) all LUNs of all targets on a specific adapter:# qaucli -pr fc -m (<hba instance> | <hba wwpn>) deselect all-n (Configure HBA Parameters)To set a specific parameter on a specific adapter port, issue the followingcommand:# qaucli -n <hba instance> | <hba wwpn> { <param name> <param value> }To restore the factory default adapter parameters (not supported for 2Gbadapters), issue the following command:# qaucli -n <hba instance> | <hba wwpn> { <param alias> <param value> }To update the adapter port parameters using a pre-defined OEM default template,issue the following command:# qaucli -n <hba instance> | <hba wwpn> | <all> defaultWhere:The pairs <param name> <param value> and <param alias> <param value> canbe repeated to set multiple parameters with a single command.hba instance = Adapter number (use the -g command to find)hba wwpn = World wide port name of the adapterparam name = Name of the parametersparam alias = Alias of the parametersparam value = New value of the parametersdefault One of the following OEM names:EMC = EMC-specific settingsHP = HP-specific settingsIBM = IBM ® -specific settingsQLGC = QLogic-specific settingsSUN = Sun ® or Oracle-specific settings
