7–iSCSI Noninteractive Commands-ipdhcp (Configure IP Settings)7-14 SN0054667-00 G-ipdhcp (Configure IP Settings)To set the adapter to get its IP address, subnet mask, and gateway from theDHCP server, issue the -ipdhcp command as follows:-ipdhcp <hba_port_inst> [-option]If the adapter port had prior values set manually, the DHCP values replace them.Where [option] includes:-l (List LUN Information)Use the -l command to view the following information about LUNs attached tothe selected target: Adapter, target, or LUN number Vendor name Product ID Product revision LUN sizeF = Configure the firmware.N = Configure the network parameters.I = Configure the iSCSI name.T = Configure the targets.C = Configure the CHAP table.B = Configure the boot parameters (only valid when theT [targets] parameter is also specified).file_name = The XML file with the adapter configuration. See“-save (Save Host Configuration)” on page 7-24).-DISN4 = Disable IPv4 network-IPV4DHCP = Set DHCP ON-IP = Set IP Address-IPNM = Set IP Netmask-IPGW = Set IP Gateway-DISN6 = Disable IPv6 network setup-IPLLA = Set local link address automatically-IPLL = Set local link address manually-IPRA = Set IPR0 and IPR1 automatically-IPR0 = Set routable address 0 manually-IPR1 = Set routable address 1 manually-IPRAA = Set router address automatically-IPRR = Set router address manually
