178Integrator ModeUNDERSCANThis function causes the outer edge of the display to appear, beyond the normal effective data area for a video signal.[Method of Use]After setting the UNDERSCAN setting to ON and leaving the MENU mode, select ‘UNDERSCAN’ with the remotecontrol’s SCREEN SIZE button.NoteDue to signal path loss or internal-circuit loss, the position may shift a little. However, since the display positioncannot be adjusted using SIZE adjustment, adjust the display position at the source.IMAGE PROCESSMatch the image to a specified display use.NORMAL .......... Performs a normal displayPURE ................ Displays the input image as faithfully as possibleMONO TONE ... Cuts the color components of the image signal to display only the brightness signalHIGH CNT ......... Strengthens the contrast above the NORMAL level to raise the color temperature to approximately+2000 KNoteEven when set to ‘MONO TONE’, color appears according to the adjustment of the white balance. To correct this,readjust the white balance.SIGNAL TYPEWhen performing YC separation (CVBS signal only) or IP conversion processing (interlace signal only), it is possibleto set the image quality for a still image.Normally, MOTION is set.When performing YC separation or IP conversion processing, STILL locks the still image without showing motion.On a still image screen that may screen to have motion (blades of grass or forest), set to STILL.Screen rolling may occur occasionally depending on the degree of degradation of the input signal. If this happens,Set to NON STD to solve this issue.Notes• When STILL is set for a moving image, the picture quality may deteriorate.• 3D Y/C processing is not performed in the NON STD mode. When this mode is set for a standard signal color,noise slightly may increase. Switching CTI to OFF can alleviate color noise depending on the screen pattern (referto section 5.3.7, “5) CTI Setting” (pg. 135)).• The NON STD mode is effective for NTSC CVBS (composite video signal).
