| 
111Operation in the normal-operation mode• Power ON/OFF• Switching input• Switching screen size• Volume adjustment• FUNCTIONAL LOCK settingAdjustments and settings in themenu modeAdjustments and settings in theintegrator modeAdjustments and settings in theRS-232C adjustment• 3 seconds after an operation• When the standby mode is designated by a remote-control, main-control panel or command• When the format of the displayed signal changes(NOTE) Of the RS-232C commands that can be used in the normal-operation mode, there aresome that cannot be saved in the last memory when using the normal-operation mode.For details, refer to section 5.5, “RS-232C Adjustment (pg. 192)”.• 3 seconds after an operation• When the standby mode is designated by a remote-control, main-control panel or command• When the format of the displayed signal changes• 3 seconds after an operation• When the standby mode is designated by a remote-control, main-control panel or command• When the format of the displayed signal changes• 3 seconds after a command is sent, or when the next command is sent within 4 seconds• When the standby mode is designated by a remote-control, main-control panel or command• When an adjustment or setting is changed using a command• When the format of the displayed signal changesItem Saving to MemoryNoteIf the system is started or stopped by turned ON/OFF from a circuit breaker, use the system only after first savingadjustments and settings in the last memory according to the timing described above. Also, with this operating method,count errors may occur in the hour meter.5.1.6 AgingAfter the power has been turned ON, input a white 100% signal to age thus stabilize the unit (about 30 minutes). Whenadjustments are made after aging is performed, it possible to perform more precise adjustments.NoteWhen a still screen is displayed for a long period, the image may possibly be burned in to the screen.5.1.5 Last MemoryThe timing for the last memory is listed below.When one of the following operations is performed before the timing is complete, the last memory function may notperform.• MAIN POWER switch is turned OFF• Power cord is removed from the power outlet• The breaker to the power outlet is turned OFFBefore Beginning Adjustments |
