150Menu Mode17) Auto Function Mode SettingWith the Auto Function mode it is possible to automatically change the input when a signal is detected.Factory setting: OFF1 Select ‘OPTION’.2 Place the cursor over ‘AUTO FUNCTION’ then press the[SET] button to change the setting.Each time the [SET] button is pressed, the setting changesas shown below.• When INPUT1 or INPUT4 is selected, this functionautomatically switches to that input when the signal isdetected. Also, in the Auto Function mode, after the inputswitches and the signal input stops, the Auto Functionreturns to the input that was used before the switch.Notes• The Auto Function mode is unavailable when ‘OFF’ is selected.• When SYNC ON G or a component signal is input to INPUT1, the Auto Function is unavailable.• After the input has been switched in the Auto Function mode, press the [INPUT] button and select a differentinput. The Auto Function mode activates when it detects a change in the selected input signal (from a no-inputstate to an input state).• When the power is turned OFF/ON, the Auto Function mode activates when the signal is input to the selectedinput.• The Auto Function mode is unavailable when the Menu displays, during POINT ZOOM, or during multi-screendisplay.• When the Auto Function mode is set to ‘INPUT1’ or ‘INPUT4’, ‘AUTO’ appears under the option that displays theselected input (INPUT1 to INPUT5).• When a video card other than a PDA-5003/PDA-5004 is installed, the Auto Function mode does not function evenwhen set to ‘INPUT4’.Screen 2MENU INPUT1CHANGESET EXITMENUSCREEN SETUP OPTIONL A N G U A G EE N E R G Y S AV ET I M E R S E T T I N GS C R E E N M G T.S P L I T F R E E Z EA U T O S E T U P M O D EA U T O F U N C T I O NP I P D E T E C TPICTURE: S TA N D A R D: I N A C T I V E: O F F: A C T I V E: E N G L I S H: O F F3 OFF 3 INPUT1INPUT4 2
