Panasonic Viera TC-22LR30 Operating Instructions Manual

Also see for Combo TC-22LR30: Technical guide Service manual

Contents

Panasonic Viera TC-22LR30 Operating Instructions Manual Manual pdf 71 page image

71InformationThese displays will alert you to a missed operation or provide further instructions.Helpful HintsWarning and Instruction DisplaysOSD CAUTION PageERROR HAS OCCURREDPLEASE PRESS ENTER.• A serious, but temporary error has occurred and one of the unit's safety devices has activated.Press ENTER. The unit switches to the standby mode. Press POWER to turn the unit on again. –NO DISC • You haven’t inserted a disc. Correctly insert a disc that this unit can use. 9, 34• The disc is upside down. If it is a single-sided disc, insert it so the label is facing up. 34THIS ISNON-RECORDABLE DISC • The unit cannot record on the disc you inserted. Insert a DVD-RAM or unfinalized DVD-R. 9THIS DISC (CARD) IS NOTFORMATTED PROPERLYPLEASE FORMAT THE DISCIN DISC SETTING TO RECORD• You inserted an unformatted DVD-RAM or Card. Format the disc or card with this unit. 61CANNOT FINISH RECORDINGCOMPLETELY• The program was copy-guarded. –• No space left on the disc.→ Create space by erasing any unwanted programs. RAM→ Use a new disc. RAM DVD-R52• Recording was not completed for some other reason. –CANNOT RECORDDISC IS FULL • No space left on the disc.→ Create space by erasing any unwanted programs. RAM→ Use a new disc. RAM DVD-R52CANNOT RECORDMAXIMUM NUMBER OF TITLESEXCEEDED• The operation is prohibited by the unit or disc. 44CANNOT READPLEASE CHECK THE DISC • The disc is dirty. –CANNOT PLAY • You inserted an incompatible disc (Discs recorded in PAL video etc.). 8PLEASE CHANGE THE DISC • There may be a problem with the disc. Press OPEN/CLOSE to remove it and check it forscratches or dirt. (The unit turns off automatically after you open the tray.) –NO SD CARDNO VALID SD CARD• The card is not inserted. If this message is displayed with a compatible card already inserted,turn off the power, remove and then re-insert the card. 34• The card format does not match. 11• The card inserted is not compatible. 11NO FOLDER • There is no compatible folder in this unit. 11CANNOT WRITE • The card is currently protected → Release the write protection. 11• There is no space remaining. → Erase any unwanted files (still pictures). 55, 56NO READ• The disc is dirty or badly scratched.→ Clean the disc if it is dirty.→ The disc cannot be played if it is scratched and this display doesn’t disappear.10• The unit cannot read the disc. –• You have used a DVD-RAM/PD lens cleaner and it has finished. 76UNSUPPORT • You have inserted a disc the unit cannot play or record on. 8~9U14• The unit is hot.→ The unit switches to standby automatically for safety reasons and you cannot operate it.Wait for about 30 minutes for the service number to disappear.→ Select a position with good ventilation when installing the unit.→ Do not block the cooling fan on the rear of the unit.–U99 • The unit fails to operate properly. Press POWER to switch the unit to standby. Now pressPOWER again to turn the unit on. –SLF CHECK • There was a power failure or the AC plug was disconnected while the power was on. The unit iscarrying out its recovery process. Wait until the message disappears. –