Panasonic Viera TC-22LR30 Operating Instructions Manual

Also see for Combo TC-22LR30: Technical guide Service manual

Contents

Panasonic Viera TC-22LR30 Operating Instructions Manual Manual pdf 72 page image

72 For assistance, please call : 1-800-211-PANA(7262) or, contact us via the web at:http://www.panasonic.com/contactinfoCheck the following points once again if you are having trouble with your unit.PROBLEM CORRECTION PagePowerNo power... • Insert the AC power supply cord securely into a known active AC outlet. 15• Set POWER to ON. 12, 13OperationCannot operate the DVD... • Press DVD when operating DVD. 34• Some operations may be prohibited by the disc. 36~37Cannot operate the SD (Card)... • Press SD when operating card. 34The unit is on but cannot be operated... • Recording drive or playback drive have not been selected properly. 34• Some operations may be prohibited by the disc. 36~37• The unit is hot (“U14” appears on the display). Wait until “U14” disappears. 71• One of the unit’s safety devices may have been activated.Reset the unit as follows:(1) Press POWER on the main unit to switch to standby. If the unit doesn’t switch tostandby, press and hold POWER on the main unit for about 10 seconds. The unitis forcibly switched to standby. Alternatively, disconnect the AC power supply cord,wait 1 minute, then reconnect it.(2) Press POWER to turn the unit on.–Cannot eject a disc... • The Disc Tray can be locked/unlocked.[Lock]1 Turn the unit Power ON.2 Simultaneously press STOP on the unit and POWER on the Remote Control.[Unlock]Repeat above steps to unlock.–• If the steps above do not work, there may be a unit malfunction. With unit in OFFcondition, hold down both STOP and CH ▲ buttons on the unit for about 5 seconds.Remove disc. Contact your retailer.RemoteControlThe Remote Control doesn’t work... • The batteries are depleted. Replace them with new ones. 8• Point the Remote Control at the Remote Control sensor on the main unit.• Remove obstacles between the Remote Control and main unit. –PictureThe images from this unit do not appear onthe television... • Make sure your antenna system (TV or CABLE) is correctly set. 15Picture flickers...Picture is not sharp... • Make sure the antenna location, direction or connection. 15Spots appear on screen, the screen flickers...• The unit may be receiving influence, such as electromagnetic wave interference orinduced electromagnetic wave from geomagnetism or external forces (automobile,electric train, power lines, neon light, motor, magnetized metal framework of a building,metal shutters, etc.).–The top and bottom parts of the screen areblank...• Using picture media wider than 16:9, such as cinema vision size media, etc. mayproduce blank portions at the top and bottom of the screen. –Using Zoom or Just causes top and bottomof screen to disappear...• The screen position may be out of adjustment.→ Adjust the screen position. 26There is a lot of after-image when playingvideo... • Select “MPEG NR” in the OTHER ADJUST menu to “OFF”. 33Before Requesting Service