Panasonic Viera TC-22LR30 Operating Instructions Manual

Also see for Combo TC-22LR30: Technical guide Service manual

Contents

Panasonic Viera TC-22LR30 Operating Instructions Manual Manual pdf 25 page image

25TV Operation Top view Select desired channel:Press CH ▲▼ or NUMBER keys. Adjust desired volume level:Press VOL + or VOL –.Selecting Input ModeUsing the CH/VOL Button TUNER:Signal of source connected to VHF/UHF terminal is displayed. VIDEO 1:Signal of source connected to AV Input terminal 1 is displayed. VIDEO 2:Signal of source connected to AV Input terminal 2 is displayed. COMPONENT:Signal of source connected to COMPONENT Input terminal isdisplayed. HDMI:Signal of source connected to HDMI Input terminal is displayed.When selecting CABLE channels 100 to 125 with the NUMBERkeys.1 Press R-TUNE to display the last channel you werewatching. Example 1:To select channel 125, first press the 1 key, then 2, then 5. Example 2:To select channel 12, first press the 1 key, then 2. Example 3:To select channel 2, first press the 0 key, then 2.Rapid TuneVIDEO1*COMPONENT*VIDEO2*HDMI*TUNER*Using the NUMBER keysThis unit can be set for auto power off.1 Press SLEEP repeatedly to select the desired time.• To cancel, press SLEEP repeatedly until “0” appears.2 The indication goes off a few seconds after theadjustment is finished.• Pressing DISPLAY with sleep timer set displays remaining time.• From 3 minutes prior to power off, 3, then 2, then 1 flasheson-screen.Sleep Timer30 600 909 0INPUTNUMBER keys▲▼◄►AUDIOASPECT DISPLAYENTERMENUR-TUNEVOL +/-CH ▲▼MUTESLEEP* If SKIP is set as the INPUT LABEL setting, the mode will not be changed.(p. 28)1 Press INPUT.• The display will change as follows.TV OperationINPUT VOL +/-Method 11 Press CH ▲▼.• The display will change as follows.Notes:• The diagram at right is an example.• TV CH 2 and CABLE CH 1 represent thelowest channels in memory, while TV CH69 and CABLE CH 125 represent thehighest channels in memory.(TV)CH69(CABLE)CH125(TV)CH2(CABLE)CH1VIDEO1*COMPONENT*VIDEO2*HDMI** If SKIP is set as the INPUT LABEL setting,the mode will not be changed. (p. 28)Method 2CHANNEL ▲▼