Panasonic VL-SW250BX Operating Instructions Manual

Also see for VL-MW250BX: Installation guide Installation guide

Contents

Panasonic VL-SW250BX Operating Instructions Manual Manual pdf 45 page image

45Expanding the SystemSetting a repeater (REGISTRATION)You can set up to 2 optional repeaters (page 4).LOne repeater can relay radio waves betweenthe main monitor station and multiple submonitor stations.LIf you set a repeater between the main monitorstation and sub monitor stations located at adistance, the repeater expands the radio waverange and may improve image distortion and/orsound cutting in and out.Perform the following operations to register the repeater to the main monitor station, then install the repeateraccording to the Operating Instructions included with the repeater.Registering the repeater to the main monitor station (REGISTRATION)Place the repeater near the main monitor station and then operate the repeater within 2 minutes in succession tothe operations of the main monitor station.Using the main monitor stationXX{OFF}{PAGE}{MENU}{VOLUME}1 Press {MENU}, then select “REGISTRATION/CANCELLATION” by pressing {VOLUME} (▲ ) or{PAGE} (▲).FUNCTION SETTINGSTIME AND DATE SETTINGSRING TONE SETTINGSCONNECTED DEVICE SETTINGSREGISTRATION/CANCELLATION2 Press {MENU} (OK), then select “REGISTRATION”by pressing {VOLUME} (▲ ) or {PAGE} (▲).3 Press {MENU} (OK), then select “REPEATER” bypressing {VOLUME} (▲ ) or {PAGE} (▲).4 Press {MENU} (OK), then select the repeater to beregistered by pressing {VOLUME} (▲ ) or{PAGE} (▲).5 Press {MENU} (OK).Operate with the repeater within 2 minutes.VL-FAN1STATUSIN USE (LED)PROGRAMPROGRAM{PROGRAM}STATUS indicatorTo power outlet(100 – 240 V AC)6 While the power is on, press and hold{PROGRAM} for about 3 seconds.LThe STATUS indicator flashes in green.LAfter completing the registration, the indicatorlights up solid.7 To end the operation, press {OFF} on the mainmonitor station.Important:LIf you register two repeaters, please separate themmore than 3 meters to avoid electrical noise.Using the repeater