Panasonic VL-SW250BX Operating Instructions Manual

Also see for VL-MW250BX: Installation guide Installation guide

Contents

Panasonic VL-SW250BX Operating Instructions Manual Manual pdf 18 page image

Doorphone18Answering a callWhen you receive a call from a door station, the main monitor station and the sub monitor station ring and theTALK indicators flash. You can monitor the visitor on the monitor display before answering a call.XX{OFF}{PAGE}{MENU}{VOLUME}{TALK} andindicatorMicrophone{VOICE CHANGER}MicrophoneTALK indicator{TALK}{D}{OFF}{MENU}{▲ } {▲} {▲ } {▲ }1 When a ringer tone is heard, press {TALK}.2 Speak to the visitor within 50 cm of the microphone.LSpeak alternately with the visitor.(If you and the visitor speak at the same time, you will not hear each other.)3 To end the conversation, press {OFF}.Note:LIf you do not answer a door call within 30 seconds, the display will turn off.A conversation will be automatically disconnected in about 90 seconds and then the display will turn off.LThe image taken by the door station is automatically recorded (page 24).When using an additional door station:LWhen you receive another call from the other door station during a conversation, see page 22.Answering a call by voice sensor (Voice answer mode)This mode allows you to answer a call by voice without pressing {TALK}. (You can operate this feature in thesame way by using either the main monitor station or the sub monitor station.)Voice answer must be set “ON” beforehand (page 37, 41).1 When a ringer tone is heard, answer with a clear voice such as “Yes?” or “Hello?”.LWhen a beep sounds, you can talk to the visitor.Note:LMake sure you are within about 50 cm of the main monitor station or the sub monitor station.LThe visitor cannot hear your initial reply when you answer with voice.LYour initial reply should be brief (less than 1 second), otherwise the voice answer mode will not start.LIf a visitor calls you, a loud, brief sound (such as a dog’s bark) may start the voice answer mode even thoughyou have not replied by voice.LWhen you locate the sub monitor station near the main monitor station, the voice answer mode may be startedby a ringer tone.LThe voice answer mode is also available for paging calls.