Panasonic VL-SW250BX Operating Instructions Manual

Also see for VL-MW250BX: Installation guide Installation guide

Contents

Panasonic VL-SW250BX Operating Instructions Manual Manual pdf 34 page image

Programming34Changing the ringer toneYou can change the ringer tone that is heard when receiving calls from the door station by using the mainmonitor station or the sub monitor station. (The ringer tone of the paging call cannot be changed.)Main monitor station1 Press {MENU}, then select “RING TONESETTINGS” by pressing {VOLUME} (▲ ) or{PAGE} (▲).2 Press {MENU} (OK), then select “RING TONE” bypressing {VOLUME} (▲ ) or {PAGE} (▲).3 Press {MENU} (OK), then select the desired doorstation by pressing {VOLUME} (▲ ) or{PAGE} (▲).DOOR STATION 1DOOR STATION 24 Press {MENU} (OK), then select the desired ringertone by pressing {VOLUME} (▲ ) or {PAGE} (▲).RING TONE/DOOR STATION 1●SOUND 1SOUND 1 (REPEAT)SOUND 2SOUND 2 (REPEAT)CurrentsettingLThe selected ringer tone sounds.LThe ringer tone sounds just once in this stepeven if you select “(REPEAT)”.5 Press {MENU} (OK).L“r” moves to the selected item.6 To end the operation, press {OFF}.Sub monitor station1 Press {MENU}, then select “RING TONE” bypressing {▲ } or {▲}.2 Press {D} (OK), then select the desired doorstation by pressing {▲ } or {▲}.DOOR 1DOOR 23 Press {D} (OK), then select the desired ringer toneby pressing {▲ } or {▲}.TONE/DOOR11/6●SOUND1SOUND1 REPEATSOUND2SOUND2 REPEATCurrentsettingLThe selected ringer tone sounds.LThe ringer tone sounds just once in this stepeven if you select “REPEAT”.4 Press {D} (OK).L“r” moves to the selected item.5 To end the operation, press {OFF}.N Ringer tone patternsThe default settings are: Door station 1 “SOUND 1”, Door station 2 “SOUND 2”Ringer tone for calls from the door stationSOUND 1SOUND 1 (REPEAT)* 1SOUND 2SOUND 2 (REPEAT)* 1SOUND 3SOUND 3 (REPEAT)* 1* 1 The selected tone rings about every 5 seconds. However, the ringer tone heard at the door station or theringer tone when receiving another call does not ring repeatedly.