6913Setting Flash(See “Introduction to Optional Accessories” on page 145)When shooting stills, you can use the optional VW-FLH3 *1 Flash (P. 145). Refer to the Flash manual forinstructions.* 1 Only for VDR-M75PP/VDR-M95PP* 2 Without light emission, the “ A” display is clearedwhen you press the Photo shot button halfway.When using the flash, if you press the Photo shotbutton half-way the indication will change to “ ”.Note :• The DVD Video Camera automatically sets the shutterspeed between 1/800 and 1/30 second (between 1/800and 1/10 second if Program AE has been set to LowLight) depending on subject brightness (P. 80 ).• The available range of the Flash is about1 - 4 m.• See “Switching Quality of Still Image (Quality)” onpage 85 if you want to change the still quality mode.• Dark subjects may not be in clear focus even if the Flashis used. It is recommended that you illuminate a subjectwhen recording in a dark place.• When you use accessories for hot shoe (only optionalVW-FLH3), the power is supplied by this DVD VideoCamera. (Only for VDR-M75PP/VDR-M95PP.)• The built-in flash cannot be used together with theseparately sold Flash.• If a separately sold Flash is connected, it is given priority.(Only VDR-M95PP.)Setting ofFlashOn-screeninformationManner ofemitting lightAUTO A * 2 Automaticallyemits light in darkplace or in a placelit from rear.ON Always emits lightregardless ofbrightness.OFF No light emission.
