6813Built-in Flash (Only for VDR-M95PP)When recording photos in a dark place, or if thesubject is lit from rear, the VDR-M95PP makes useof the built-in flash for automatic brightening: Theflash can also be set to “On” where the light isalways being emitted, or “Off” when you wish torecord without using the flash even in a dark place.* 1 Without light emission, the “ A ” display is clearedwhen you press the Photo shot button halfway.When using the flash, if you press the photo shotbutton half-way the indication will change to “ ”.1 Press the MENU button, and choose “Flash”from the “Camera Functions Setup” menuscreen.2 Choose the option for“Flash”.3 Press the MENUbutton to end setting.Note :• When recording dark subjects without using “Flash”, theshutter speed will be slower, so don’t let the camerashake.• The “Flash” setting will not change even when the DVDVideo Camera is turned off. Unless recording is to bemade with the fixed “Flash” setting, it is recommended toreturn it to “Auto” after recording with the “On” or “Off”setting, before turning the DVD Video Camera off.• The flash automatically adjusts the amount of lightemitted, but the light amount adjustment may beinsufficient when a subject is too far away or too near.• The distance for the flash to adjust the appropriateamount of light will vary depending on the subject, but itis approximately 1 - 2.5 m.• When recording a close-up photo, specify “Flash: Off”.Using the flash too near the subject could cause a whitishimage.• “ ” will blink while the flash battery is charging.• Do not block the sensor at the top of the flash with yourfinger.Setting ofFlashOn-screeninformationManner ofemitting lightAUTO A * 1 Automaticallyemits light in darkplace or in a placelit from rear.ON Always emits lightregardless ofbrightness.OFF No light emission.Program AEWhite Bal.FlashDig.ZoomOnAutoENTER RETURN RAMOffCamera Functions Setup8 : 0 0 AMSEP 3 0 2 0 0 5394REMSensor
