36Snowy PictureMultiple ImageInterferenceNormal PictureNo PictureNo ColourPoor or DistortedPictureNormal PictureNoisy SoundNormal SoundNormal SoundNormal SoundNoisy SoundNo SoundNo SoundWeak orNo SoundWeak ordistorted soundTroubleshootingIf there is a problem with your LCD TV please refer to the table below to determine the symptoms, then carry out thesuggested check. If this does not solve the problem, please contact your local Panasonic dealer, quoting the modelnumber and serial number (both found on the rear of the TV).Symptoms ChecksThere may be red spots,blue spots and greenspots on the screenAerial location, direction or connectionAerial location, direction or connectionElectrical appliancesCars / MotorcyclesFluorescent lightsVolume levelSound mute switched on.TV set to AV modeNot plugged into AC outlet.Not switched on.Picture / Sound controls set at minimum levels.Check if in Standby mode.Retune Channel (s).Sound reception may have deteriorated.Sound systemPicture SoundColour Controls set at minimum levels.Colour systemThis is a characteristic of liquid crystal panels and is not aproblem. The liquid crystal panel is built with very high precisiontechnology giving you fine picture details. Occasionally, a fewnon-active pixels may appear on the screen as a fixed point ofblue, green, or red.Please note this does not affect the performance of your LCD.HDMI cable is not connected securely.Turn the power supply of the TV and connected equipment offthen turn on.Check compatibility of input signal from the connected equipment.The connected equipment must be EIA/CEA-861/861B compliant.Change the audio setting of the connected equipment to L.PCM.Check the setting of HDMI input in Sound menu.If the problem is due to the digital audio connection, change tothe analogue audio connection.Poor Video.(Snow noise, no picture, picture runs, etc.)Poor Audio.The error message appears.The SD card cannot be used even when it is formatted.Please consult an Authorized Service Center.Please consult an Authorized Service Center.HDMI