Panasonic TX-26LX500A Operating Instructions Manual

Also see for TX-26LX500A: Service manual Service manual

Panasonic TX-26LX500A Operating Instructions Manual Manual pdf 10 page image

10Audio / Video connectionsHow to connect the PC Input terminalsNotes:• Connect a cable which matches the audio output terminal on the computer.• Computer signals which can be input are those with a horizontal scanning frequency of 31 to 69 kHz and verticalscanning frequency of 59 to 86 Hz. (However, the image will not be displayed properly if the signals exceed 1,024 lines.)• When the aspect mode is set to “4:3”, maximum of 1,024 × 768 dots area of LCD panel is used for display, andwhen the aspect mode is set to “16:9”, full area (1,366 × 768 dots) of LCD panel is used for display.• Some PC models cannot be connected to the set.• There is no need to use an adapter for computers with DOS/V compatible D-sub 15P terminal.• The computer shown in the illustration is for example purposes only.• Additional equipment and cables shown are not supplied with this set.• Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the specifiedfrequency range.• For applicable PC signals information see page 37.Signal Names for D-sub 15P ConnectorAV INLRAUDIOINPCS VIDEOCOMPONENTMONITOROUT AV1IN AV2IN AV4INVIDEOLAUDIORP B /CBYPR /CRMONO MONO MONOU . S . p a t e n t N o . 4 , 9 0 7 , 0 9 3 .LRPC INAUDIO INCOMPUTERRGBAUDIO(D-sub 15p)(Stereo plug)Conversion adapter (if necessary)167839451015 14 13 12 112 Pin No. Signal Name Pin No. Signal Name Pin No. Signal Name1 R 6 GND (Ground) 11 NC (not connected)2 G 7 GND (Ground) 12 NC (not connected)3 B 8 GND (Ground) 13 HD/SYNC4 NC (not connected) 9 NC (not connected) 14 VD5 GND (Ground) 10 GND (Ground) 15 NC (not connected)Pin Layout for PC InputTerminalPower On / OffConnect the mains plug to the wall socket.Press the [ ] switch on the TV set to turn theset on.To switch the TV set to Standby mode, press thebutton on the remote control.The TV set can be switched on by pressing thebutton again if it was in Standby mode.Note:This TV will still consume some poweras long as the mains plug is still insertedinto the wall socket.TV1 2 34 5 67 8 90OKPower IndicatorRemote control signal sensorWithin about 23 feet (7 meters) infront of the TV set.Standby : RedOn : No LightC.A.T.S. sensorLCD C.A.T.S. (Contrast Automatic Tracking System) automaticallysenses the ambient light conditions and adjusts the brightnessand gradation accordingly, to optimize contrast.C.A.T.S. is in effect when Menu mode (page 17) is set to Auto.Main POWER switch