Panasonic TX-26LX500A Operating Instructions Manual

Also see for TX-26LX500A: Service manual Service manual

Panasonic TX-26LX500A Operating Instructions Manual Manual pdf 15 page image

155. 5MHz1Manual tuning-, + : SearchTV / AV : Move cursorSTR : To storeF : To exitSTR F - / + / TV / AVTuningPress the MENU button.Move to choose Setup menu.Access Setup menu.Move to choose Tuning menu.Access Tuning menu.Move to choose Manual tuning.Access Manual tuning.Select the programme position to be tuned.Press repeatedly until required station is found.When the desired station is found, press the OK button to store.The programme position will flash.Press the EXIT button at any time to go back to watching TV.It is possible to retune individual programme positions:It is also possible to use the control panel buttons on the front of the TV to tune individual programme positions:STR F TV/AV1Manual tuningSearch down/upStoreProgramme down/upReturnExitMENUOKOKTV1 2 34 5 67 8 90OKPress F until Tuning mode is reached.Press –/ or +/ to access Tuning mode.Press F until Manual tuning is reached.Press –/ or +/ to access Manual tuning.Press TV/AV to move between Change Programme, Searchand Change sound system.Press –/ or +/ to change programme position or start search.When the desired station is found, press STR to store.The programme position will flash.Repeat above procedure to tune additional programme positions.Press F at any time to exit the Tuning menu.EXITManual tuning (via front panel)Notes:• If a clear picture cannot be obtained even when a Broadcast or AV signal is received, refer to the Colour systemselection on page 13.• After the Manual tuning is finished, press the Programme Number up button to confirm the tuning condition for eachProgramme Numbers. If some Programme Numbers are unused, it is possible to skip such Programme Numbers.Please refer to the Skip function on page 13.• When using a VCR without video and audio input / output terminals, it is convenient to connect the aerial cable asindicated in the instruction manual of VCR and to set the designated channel to Programme No.“0”. In that case,perform Manual tuning after setting the Colour system and Sound system in advance. Further, in multi-systemVCR, it is more convenient to set the designated channel to several Programme Numbers.Manual tuning