Panasonic TH-75BQE1W Operating Instructions Manual

Also see for TH-65BFE1W: Operating instructions Service manual

Contents

Panasonic TH-75BQE1W Operating Instructions Manual Manual pdf 44 page image

44English■ Menu screen of settingsSetupSchedulerSignal Check PriorityControl SettingSleep TimerNo Activity Power OffOffOFFOffDisableOnPower On MessageInitial StartupEDIDSoftware Update(USB)Last Memory300 Sec1.4Power Management SettingRestore DefaultMenu screen of settings[Scheduler] Changes the settings of the scheduler.[Signal Check Priority] Sets priority of the signal between 1 and 5 ([Priority 1] is the highest). When the existingsource signal is lost, the display will search for a new signal source according to thesignal check priority.• When [Signal Check Priority] is enabled, the display will search for an enabled signalsource according to the settings of signal check priority when the power supply isturned on.• When there is no signal source of [Priority 1], the display will check other sources inthe higher order of priority and it will appropriately change the source.• When the highest priority signal source is restored, the display will automaticallychangeover to this source once again.• When [Signal Check Priority] is disabled, the display will use the source used lastwhen the power supply is turned on.• When [Signal Check Priority] is enabled, the system will automatically play USB if thesource was USB when the power supply was on.----------Signal Check PriorityEnable Signal CheckInputPriority 1Priority 2Priority 3Priority 4Priority 5Reset Setting[Control Setting] Select so that the LCD display is controlled via the serial terminal.[Sleep Timer] Changes the settings of sleep timer, or turns off the sleep timer.[No Activity Power Off] Enables / disables the function of automatic standby when the device is not operatedfor about 4 hours or more.[Power On Message] You can show / hide the startup message display when [No Activity Power Off] isenabled.• You cannot set this if [No Activity Power Off] is [Disable].[Initial Startup] [Last Memory], [Standby], [On][Power ManagementSetting] Changes the settings of power management, or turns off the power management mode.[EDID] Setting the EDID version to suit for video equipment will enhance the compatibilitybetween this unit and video equipment.[2.0]: Enhances the compatibility to the equipment that can output images of resolutionhigher than 1 920 x 1 200.[1.4] (Default setting): Enhances the compatibility to the equipment that can outputimages of resolution 1 920 x 1 200 or less.• When no image is output from video output devices (PC, DVD player, etc.), switchingthe setting of EDID.[SoftwareUpdate(USB)] Updates the software via the USB terminal (for service).[Restore Default] Settings will be restored to the factory default settings.