67SETUPNetwork Setup LAN SetupDetailed network settings for the LAN established via the LAN terminal of the Display or twisted pair cable transmittercan be configured.Network settingsDIGITAL LINK modeNetwork controlOffAutoOffDisplay nameLFV70-00LAN setupDIGITAL LINK statusDigital Interface BoxAMX D. D.Crestron ConnectedTMOffOffExtron XTPResetLAN setupSaveDHCP OnIP address 169 254 1 1255 255 0 00 0 0 10Subnet maskGatewayPortMAC address102400:00:00:00:00:00Select “LAN Setup” and pressDHCP, IP address, Subnet mask, and Gateway settings1 Set DHCP.When “Off” is selected, IP address and other settings can be setmanually.2 Select the item and press .3 Enter an address.I192.168. 0. 8IP ADDRESS 1 Use to select a digit.2 Use to change a number.3 Press .Pressing will cancel the address change.4 Select “Save” and press .PORT setting1 Select “Port” and press .2 Enter a port number.I01024PORT 1 Use to select a digit.2 Use to change a number.3 Press .Pressing will cancel the port number change. SaveSave the current network Setup. Each value set for DHCP,IP address, Subnet mask, and Gateway will be saved. If“NG” is displayed, check the same IP address is not usedwithin the same network. DHCP (DHCP client function)To obtain an IP address automatically using a DHCPserver, set this to “On”. If DHCP server is not used, setthis to “Off”. IP address (IP address display and setting)Enter an IP address if DHCP server is not used. Subnet mask (Subnet mask display and setting)Enter a subnet mask if DHCP server is not used. Gateway (Gateway address display and setting)Enter a gateway address if DHCP server is not used. PortSet the port number used for command control.The available setting range is 1024 – 65535.When the PJLink™ protocol is used, the port setting is notnecessary. MAC AddressDisplay the MAC address of this unit.Note:Shipping condition is below.[DHCP]: Off[IP address]: 192.168.0.8[Subnet mask]: 255.255.255.0[Gateway]: 192.168.0.1Notes:• To use a DHCP server, make sure the DHCP server is started.• Contact your network administrator for details on settings.