88USB Media Player3. Network environment (Multi Media Player only)3.1. Example of setting up LAN connection and IP address / Subnet maskAs mentioned below, connect several units of LFV70 together with LAN cables and set up IP addresses / Subnet masksso that all panels exist on the same network.MasterIP address:Subnet mask:192.168.0.1255.255.255.0192.168.0.2255.255.255.0192.168.0.3255.255.255.0192.168.0.4255.255.255.0SlaveSlaveSlaveHub or boradband routerNotes:In order to prevent network traffic congestion, try not to establish connection with any other equipment.With a router put in between, you cannot set up connection. Use them within the same subnet.Set the network configuration to ON.Since it may be unable to operate normally, please do not connect by wireless LAN.Use video files which use the same codec and bitrate within the USB memory.Use still picture files which use the same display size and compression rate within the USB memory.Use the same and higher-speed USB product.Use in an environment almost free from network communication failure (less communication data amount).4. Procedures for starting / ending Media Player4.1. For Single Media PlayerStarting procedure(1) Insert USB memory for Media Player. *See chapter 2(2) Run a USB memory contents check. *See chapter 2.6If an error arises, repeat the check until the error is eliminated.(3) Change INPUT to USB.Ending procedure(1) Change INPUT to other than USB.4.2. For Multi Media PlayerStarting procedure(1) Connect several units of LFV70 with LAN cables. *See chapter 3(2) Insert USB memory for Media Player into each LFV70. *See chapter 2(3) Run a USB memory contents check on each LEV70. *See chapter 2.6If an error arises, repeat the check until the error is eliminated.(4) Change INPUT for Master to USB.