Panasonic TH-50LFC70U Operating Instructions Manual

Also see for TH-50LFC70E: Operating instructions

Contents

Panasonic TH-50LFC70U Operating Instructions Manual Manual pdf 50 page image

StartFunction Scrolling bar onlyTime Designation6:1512:30ModeStart TimeFinish TimeScreensaverTime 15:00StartFunction Scrolling bar onlyInterval12:003:00ModePeriodic TimeOperating TimeScreensaverTime 15:00StartFunction Scrolling bar onlyStandby after SCR Saver6:15ModeScreensaver durationScreensaverTime 15:00Side panelDo not display a picture in 4:3 mode for an extended period,as this can cause an image retention to remain on the sidepanels on either side of the display eld.To reduce the risk of such an image retention, illuminatethe side panels.This function may be applicable to the non-picture area.Off: Darken both ends.Low: Make it dark gray.Mid: Make it gray.High: Make it light gray.Note:To reduce the occurrence of image retention, set the Side panel to High.WobblingAutomatically shifts the display image (therefore unnoticeable to the eye) to prevent image retention of sharper contourof image.Note:When this function is operating, part of the screen may appear to be missing.side panel4:3 ScreenDisplayimageretention48After selecting Time Designation, Interval or Standby after SCR Saver, the relevant Time Setup will become availablefor selection and the Operating Time may be set. (Time cannot be set when “Mode” is “On” or “Off”.)Press to select Start Time / Finish Time(when Time Designation is selected).Press to select Periodic Time / Operating Time(when Interval is selected).Press to select Screensaver duration(when Standby after SCR Saver is selected).Press to setup.button: Forwardbutton: BackNote: Timer function will not work unless “Time” is set.Notes:• Pressing “ ” or “ ” button once changes the Time 1 minute.[However, switching occurs every 15 minutes when Periodic Time isselected.]• Pressing “ ” or “ ” button continuously changes the Time by 15minutes.• “Screensaver duration” of the “Standby after SCR Saver” can be set from0:00 to 23:59. When this is set to “0:00”, “ Standby after SCR Saver” willnot be activated.Screensaver (For preventing image retention)Setup of Screensaver Time