Do not stand on, or hang from the display.• Serious damage and injury might result. Pay specialattention to children and keep them out of harm’s way.Be sure to insert batteries correctly (+ and -) makesure the polarity is not reversed.• Mishandled batteries can leak, or even explodeand cause fire. This can result in serious injury anddamage to property.• Insert batteries correctly as instructed. (see page 11)Do not use batteries with a damaged or missingouter cover.(The outer cover is attached to the battery for safetyand must not be removed doing so may cause shortcircuits.)• Mishandling the batteries can cause them to shortcircuit, resulting in fire, injury or damage to property.Remove the batteries from the remote controltransmitter if it is not to be used for a long time.• A battery may leak, heat, ignite or burst, resulting infire or damage.Do not attempt to burn or break up batteries.• Batteries must not be exposed to excessive heat suchas direct sunlight, or radiators, stoves or other heatsources.Do not turn the Display upside down.Do not lay the display down with its liquid crystalpanel facing upwards.Precautions for useUnpacking• This product is packed in a carton, together with thestandard accessories.• Any other optional accessories will be packedseparately.• This display is big and heavy and two people shouldbe involved when it is moved or unpacked.• After opening the carton, ensure that the contents arecomplete and in good condition.Cautions when installingDo not set up the Display outdoors.• The Display is designed for indoor use only.Install this unit in a location which can support itsweight.• Use an installation bracket that conforms to VESAstandardsTemperature of the working environment for thisunit.• For a location that is less than 1 400m (4 593ft) abovesea level: 0°C to 40°C (32°F to 104°F)• For a location more than 1 400m (4 593ft) but lessthan 2 800m (9 186ft) above sea level: 0°C to 35°C(32°F to 95°F)Do not install the unit in a location more than 2 800m(9 186ft) above sea level.• Failure to comply with this requirement may shortenthe life of the internal parts and result in malfunction.We are not responsible for product damage, orany consequences, caused by installation in anunsuitable environment, even during the warrantyperiod.Do not place the display where it may be affected bysalt deposit or corrosive gas.• Failure to do so may shorten the life of the internalparts and result in malfunctions due to corrosion.Required space for ventilation• Make sure to leave at least 10cm (3.94”) of freespace above and below, and on both sides of theperiphery of the display.There should be at least 5cm (1.97”) or more freespace behind the display.Specifications of the screws used to secure a wallhanging bracket that conforms to VESA standardsInchmodelScrew pitch forinstallationDepth ofscrewholeScrews(quantity)49/55 400 mm × 400 mm 10 mm M6 (4)• Installing multiple displaysEnglish8