Panasonic TH-49LFV8U Operating Instructions Manual

Also see for TH-49LFV8U: Operating instructions

Panasonic TH-49LFV8U Operating Instructions Manual Manual pdf 24 page image

CommandCommand Parameter Control detailsPON None Power ONPOF None Power OFFAVL *** Volume 000 - 060AMT 0 Audio MUTE OFF1 Audio MUTE ONIMSNone Input select (toggle)HM1 HDMI1 input (HDMI1)HM2 HDMI2 input (HDMI2)DP1 Display Port IN input (DisplayPort)DV1 DVI-D IN input (DVI-D)PC1 PC IN input (PC)VD1 VIDEO input (VIDEO)YP1 COMPONENT input(COMPONENT)UD1 USB input (USB)MDC 0 Tiling Enable Off1 Tiling Enable OnAttention● Intervals between multiple commands should be atleast 750 ms.● When sending multiple commands, be sure toreceive a response from this unit before sendingthe next command. When sending a commandthat does not require a parameter, no colon (:) isnecessary.● When using the serial control, set “Eco mode” to“Normal”. ( See page 31)● When using Video Wall Manager, set “Eco mode” to“Normal”. ( See page 31)Notes● If a wrong command has been sent, the command”ER401” will be returned to the PC.● In the standby state (power turned off by remotecontrol or the Display power button)When ”Eco mode” is set to ”normal”operations otherthan the ”PON” command cannot be guaranteed.When ”Eco mode” is set to”low power standby”operations other than the”PON” command cannot be guaranteed. Also, the”PON” command does not respond.● Only commands to monitors with corresponding IDswill be accepted.The formats are shown below.(Type1) AD94;RAD:;(Type2) RAD:; represents monitor ID 001 to monitor ID100, or 000.000 is the simultaneous transmission command (IDall command) to all the monitors.● When using the monitors in a serial daisy chain, setthe Monitor ID to avoid overlapping in all displays,and use commands with ID.● For command details, consult the dealer from whichthe product was purchased.Or, visit the support site shown below.https://panasonic.net/cns/prodisplays/● Video Wall ManagerThis unit supports the “Video Wall Manager”software which adjusts multiple displayssimultaneously or separately on one computerwithout the need to rearrange cables.● For more details, visit the following web site.https://panasonic.net/cns/prodisplays/download/software/index.htmlIR terminal connectionIt is possible to receive signals from the remote controlby connecting the supplied external IR receiver to the IRIN terminal.Notes● An external IR receiver is supplied with this unit.● If the external IR receiver or the IR cable is connectedto the IR IN terminal of the Display, control is limitedto this Display.IR IN IR OUT IR IN IR OUT IR IN IR OUT12 3 45外部IR受信機External IR receiver (supplied)First displaySecond displayThird displayIR Daisy Chain Cable (supplied)USB terminal connectionConnect a USB device to use [USB media player].1USBUSB memory devicePin assignments and signal names for USB Terminal1 3 42External IRReceiverEnglish24