Panasonic SC-VK62D Operating Instructions Manual

Also see for SA-VK62D: Service manual

Panasonic SC-VK62D Operating Instructions Manual Manual pdf 5 page image

Speaker, radio and power supply connections/The remote controlENGLISH5RQT8092• Connect the AC power supply cord only after all other connections have been made.• Optional antenna connections ( AAAAA page 26).PreparationTwist and pull off the vinyl tip of the speaker cords.ORIf the speaker cords do not have vinyl tips, directly connect them to the terminals.Speaker, radio and power supply connectionsSTEP3Conserving powerThe unit consumes power (approx. 0.9 W) even when it is turned off with [f] (main unit: [f/ I]). To save power when the unit is not to be usedfor a long time, unplug it from the household AC power socket. You will need to reset some memory items after plugging in the unit.The remote controlSTEP4 Do not:• mix old and new batteries.• use different types at the same time.• heat or expose to flame.• take apart or short circuit.• attempt to recharge alkaline or manganese batteries.• use batteries if the covering has been peeled off.Mishandling of batteries can cause electrolyte leakage which candamage items the fluid contacts and may cause a fire.Remove if the remote control is not going to be used for a longperiod of time. Store in a cool, dark place.77777 UseAim at the remote control signal sensor (A page 8), avoidingobstacles, at a maximum range of 7 m directly in front of the unit.AM loop antenna FM indoor antenna AC power supply cordFor Saudi Arabia, Kuwait,the Middle East, SouthAfrica and Southeast AsiaFor Saudi Arabia and Kuwait5Remote control BatteriesR6/LR6, AA, UM-3Insert so the poles (+ and –) match thosein the remote control.• Do not userechargeabletype batteries.BE SURE TO READ THE NOTE ONAC POWER SUPPLY CORD ONPAGE 2 BEFORE CONNECTION.For Saudi Arabia and KuwaitFM indoor antennaTape the antenna wherereception is best.FM ANT(75Ω)AdhesivetapeTo household AC socketAM ANTAM loop antennaStand the antenna up on itsbase. LOOPEXT21Red (+)RedBlack ( )Black123R L+Connect the right (R) side inthe same way.Before connecting the AC powersupply cord, set the voltage.Voltage SelectorUse a flat-head screwdriver to set thevoltage selector on the back of the mainunit to the appropriate position for thearea in which this system is used.220-240V110-127VVOLT ADJ(R) (L)For Saudi Arabia, Kuwait and Southeast Asia