Panasonic SC-VK62D Operating Instructions Manual

Also see for SA-VK62D: Service manual

Panasonic SC-VK62D Operating Instructions Manual Manual pdf 20 page image

The radioRQT809220ENGLISHManual tuning1 Press [TUNER/AUX] (main unit: [BAND, TUNER]) toselect “FM” or “AM”.The unit comes on.2 Press [(] or [)] (main unit: [g, REW/ 44444] or[f, 33333/FF]) to select the frequency.Press and hold [(] or [)] (main unit: [g, REW/4] or[f, 3/FF]) until the frequency starts scrolling to start automatictuning. Tuning stops when a station is found.“TUNED” is displayed when a radio station is tuned.“ST” is displayed when a stereo FM broadcast is being received.LLLLL If noise is excessive in FMPress [PLAY MODE] to display “MONO”.Monaural sound is selected and noise reduces when reception isweak.Press [PLAY MODE] again to cancel the mode.“MONO” is also canceled if the frequency is changed.The radioLLLLL AM allocation setting (main unit only)The step is factory-set to 9 kHz, but you can change it to receivebroadcasts allocated to 10 kHz steps.1. Select “FM”.2. Press and hold [BAND, TUNER].After a few seconds the display changes to show the currentminimum frequency. Continue to hold the button down. The minimumfrequency changes and the step is changed.To return to the original step, repeat the above steps.NoteAfter changing the “allocation” setting, the frequencies you previouslypreset in the memory will be cleared. Preset them again.Preset tuningRemote control onlyThere are two methods of pre-setting stations.Automatic presetting :All the stations the tuner can receive arepreset.Manual presetting :You can select the stations to preset andthe order they are preset in.Up to 15 stations each can be set in the FM and AM bands.Preparation:Press [TUNER/AUX] to select “FM” or “AM”.Automatic presettingDo the following once each for FM and AM.Preparation: Tune to the frequency where pre-setting is to begin.Press [SHIFT] + [TUNER PGM] until the frequencychanges.The tuner presets all the stations it can receive into the channels inascending order. The last station to be set is then played.Manual presettingPre-set the stations one at a time.1 Tune to the station (A see left).2 Press [SHIFT] + [TUNER PGM].3 While “PGM” is flashing on the displayPress the numbered buttons to select a channel.Alternatively, press [g, REW/4] or [f, 3/FF] then press[SHIFT]+[TUNER PGM].The station occupying a channel is erased if another station ispreset in that channel.Selecting channelsRemote control only1 Press [TUNER/AUX] to select “FM” or “AM”.2 Press the numbered buttons or [g, REW/44444] or[f, 33333/FF] to select the channel.• To select a 2-digit numbere.g. 12: [h10] A [1] A[2].DECK 1/2BAND, TUNER, DECK1 , DECK2, TAPEDECK 1 DECK 2, DVD/CD, STOPREW/, ,, /FF, DVD/CD,, TAPESHIFT,,,TUNER/AUXPLAY MODETUNER PGMREW//FFREC7 809104 5 61 2 3NumberedbuttonsThe radio20