RQT567120TimerYYALLRANDOM1 -1PLAYRECFADERREPGMEQ ONMONOSTRECALLRANDOM1 -1PLAYRECREPGMEQ ONMONOSTRECSLEEPFADERSLEEPUsing the TimerTo check the settings (when unit is off)Press [CLOCK/TIMER].The settings are shown in the following order:Start time, Finish time Source Volume ClockTo change the settings (when unit is on)To change the timesDo steps , , , and .To change the source or volume1. Press [ PLAY/REC] to clear the timer indicator.2. Make changes to the source or volume.3. Do steps to .You can enjoy other sources after you have setthe timer.Turn the unit off before the timer’s start time.The play and record timers cannot be used together.The Sleep TimerRemote control onlySet the unit to stop and turn off after a certain time.While listening to a CD, a cassette, or the radio.Press [SLEEP] to select the time (in minutes).Each time the button is pressedSLEEP 30 SLEEP 60 SLEEP 90SLEEP OFF SLEEP 120To cancelPress [SLEEP] to select “SLEEP OFF”.To check the remaining timePress [SLEEP] once.The remaining time is shown for about 5 seconds.To change the time.Press [SLEEP] to select the new time.The sleep timer can be used in combination with the playand record timers. Make sure the unit is off before the playor record timer's set start time.The Timer FaderRemote control onlyVolume increases slowly to the set level when a timer turnsthe unit on and decreases slowly when the sleep timerturns the unit off.Press [TIMER FADER] to display “ ”.(All timers will be affected.)Press again to cancel.This feature does not affect record timer’s recordings.