Panasonic RX-EX1 Operating Instructions Manual

Also see for RXEX1 - RADIO CASSETTE W/CD: Operating instructions

Panasonic RX-EX1 Operating Instructions Manual Manual pdf 13 page image

RQT567113ListeningFM AMFADER SLEEPALLEQ ONMONOST- REC1RANDOM1 RECPGMSTFADER SLEEPALLEQ ONMONO- REC1RANDOM1 RECPGMFADER SLEEPALLEQ ONMONO- REC1RANDOM1 RECPGMFADER SLEEPALLEQ ONMONO- REC1RANDOM1 RECPGMSTSLEEPFADERALLEQ ON- REC1RANDOM1 RECPGMSLEEPFADERALLEQ ONMONO- REC1RANDOM1 RECPGMSLEEPFADERALLEQ ONMONO- REC1RANDOM1 RECPGMSTSTMONOAutoscanC-RESET FM MODE BP CD PLAYMODEAUTO SCANCLOCKTIMER TUNERTAPE CD4 5 67 9 0810PThe Radio: manual tuningPress [POWER, ] to turn the unit on.Press [TUNER BAND] to select FM or AM.Each time the button is pressed: AM FMPress [TUNE MODE] to select the manual tun-ing mode.Make sure that “ ” is not displayed.Press [REW/–/ ] or [ /+/FF] to select astation.“ ” is displayed during FM stereo broadcasts.Turn [– """""VOLUME#####+] to adjust the volume.Auto-tuningPress and hold [REW/–/ ] or [ /+/FF] until the fre-quency starts changing rapidly.Stops when it finds a station. (Interference may also causeit to stop. Start auto-tuning again if this occurs.)To stop auto-tuningPress [REW/–/ ] or [ /+/FF].Using auto scanRemote control onlyYou can search for a station by listening to all tuned-instations for 8 seconds each.1 Press [TUNER] to select “FM” or “AM”.2 Press [AUTO SCAN].Auto scan starts.3 Press [AUTO SCAN] when you find the de-sired station.Auto scan ends when it reaches the original frequency again.To stop during the process, press [AUTO SCAN].To improve receptionFM: Change the length and position of the antenna.AM: Change the facing of the unit.•AM reception is briefly interrupted if a tape deck is operated.•To improve reception when using the unit in a building orvehicle use it near a window.If noise is excessive in FMRemote control onlyPress [FM MODE/BP] to display “ MONO ”.Monaural sound is selected (“ ” goes off) and noise re-duces when reception is weak.Press [FM MODE/BP] again to cancel the mode.To receive FM broadcasts allocated in 0.1MHzMain unit onlyFirst press [TUNER BAND] to select “AM”. Now, press andhold [TUNER BAND]. The display changes in a few sec-onds to show the current lowest FM frequency. Continue tohold down the button.The minimum frequency changes and the step is changed atthe same time. Changing the step erases all preset stations.Repeat the above to change the step back.