Panasonic RX-EX1 Operating Instructions Manual

Also see for RXEX1 - RADIO CASSETTE W/CD: Operating instructions

Panasonic RX-EX1 Operating Instructions Manual Manual pdf 15 page image

RQT567115ListeningRecordingPGMALLRANDOM1EQ ONMONOST- REC1SLEEPPLAYRECFADERREPGMALLRANDOM1EQ ONMONOST- REC1SLEEPPLAYRECFADERREALLRANDOM1 -1SLEEPPLAY FADERREPGMEQ ONMONOSTRECRECALLRANDOM1 -1SLEEPPLAY FADERREPGMEQ ONMONOSTRECRECALLRANDOM1 -1SLEEPPLAY FADERREPGMEQ ONMONOSTRECRECPresent state (e.g., elapsed play time of CD)Present timeTape counterTape Counter Tape PlayingCassettesPress [POWER, ] to turn the unit on.Insert a cassette into the deck.Play starts from the side facing up.Press [3 TAPE] to start play.Turn [– """""VOLUME#####+ ] to adjust the volume.To stop playPress [7 TAPE/CD].To eject tapeStop tape play, then press [0 TAPE].One touch play (When using AC power)When a cassette is loaded, press [3 TAPE].The unit comes on and play starts.Fast-forward and rewindPress [REW/–/ ] (rewind) or [ /+/FF] (fast-forward).Selection of tapesUse normal position tapes to play correctly.High position and metal position tapes can be played, butthe unit will not be able to do full justice to the characteristicsof these tapes.Cassette tape care• Tapes exceeding 100 minutes are thin and can break orget caught in the mechanism.• Tape slack can get caught up in the mechanism and shouldbe taken up before the tape is played.• Endless tapes can get caught up in the deck’s moving partsif used incorrectly.Before RecordingUse household AC power or new batteries when recording,to avoid poor recording caused by the batteries running down.Television can cause interference to recording made on thisunit if the two are too close to each others.Selection of tapes for recordingUse normal position tapes.High position and metal position tapes can be used, butthe unit will not be able to record or erase them correctly.Volume and sound quality in recording• Recording level is set automatically.• Recording are unaffected by changes to sound quality.To display the tape counter whilerecordingRemote control onlyPress [DISPLAY].Each time you press the button in the CD or radio mode:To reset the tape counterPress [C-RESET].The counter resets to “000”.