Panasonic RX-EX1 Operating Instructions Manual

Also see for RXEX1 - RADIO CASSETTE W/CD: Operating instructions

Panasonic RX-EX1 Operating Instructions Manual Manual pdf 17 page image

RQT567117RecordingRANDOMREC11ALLRANDOM1SLEEPPLAYRECFADERREPGMEQ ONMONOSTRANDOM1SLEEPPLAY FADERREPGMEQ ONMONOSTALL -REC RECALL - REC1SLEEPPLAY FADERREPGMEQ ONMONOSTALLRANDOM1SLEEPPLAY FADERREPGMEQ ONMONOSTREC REC1-REC1-Recording CDsYou can record the whole CD (ALL-REC) or a selectedtrack(1-REC).ALL-RECPreparation: Insert a CD ( page 10)Press [99999 TAPE/CD] to switch to CD mode.Press [CD REC MODE] so “ALL-REC” is dis-played.Each time the button is pressedALL-REC 1-REC OFFThe display shows the length of tape needed.“C-- -- -- --” indicates the tape needed exceeds 100minutes. You can still record, but some tracks may notbe recorded if the tape isn’t long enough.Insert a cassette with the side for recordingfacing up.Press [ ] to start recording.The unit rewinds the tape, records 10 seconds of si-lence, and then starts recording.To stop recordingPress [ TAPE/CD]. The CD also stops.If a track is interrupted at the end of the side fac-ing upRecording and CD pauses.To record the track again on the opposite side1. Press [0 TAPE], flip the cassette, and insert it.2. Press [ ].The unit records 10-second of silence, and resumes re-cording from the beginning of the cut-off track.To record selected tracksProgram tracks ( steps and on page 12).Do steps to above.You cannot use ALL-REC with repeat or random play( page 11).1-RECPreparation: Insert a CD ( page 10) and a cassette.Wind the tape to where you want to start recording.Press [ TAPE/CD] to switch to CD mode.Press [CD REC MODE] so “1-REC” is displayed.Press [REW/–/ ] or [ /+/FF] to select thetrack you want to record.Press [ ] to start recording.CD play and recording start at the same time.To stop recordingPress [ TAPE/CD]. The CD also stops.To record a track in playPress [CD REC MODE] to display “1-REC”.Press [ ].Recording starts from the beginning of the track and stopswhen the track finishes.Recording and CD will stop when the tape reaches its end,even if the track has not finished.