130Chapter MaintenanceandInspectionsWarning and Error Display for Thumbnail OperationItem Message Description MeasureThumbnailsCANNOT ACCESS! Data cannot be accessed because it iscorrupted or for other reasons.Restore media and clips to normal statebefore access.CANNOT DELETE ! P2 card contains contents versionmismatches or bad clips.Match devices and contents versions, andrepair bad clips.CANNOT FORMAT! Formatting cannot be made due to some P2card problem. Check the P2 card.CANNOT REPAIR! Data cannot be repaired since content thatcannot be repaired is selected. Check selected content.CANNOT REPAIR INSELECTION!Some of the selected clip could not berepaired. —CARD FULL! The P2 or SD card is full. Insert media with sufficient capacity.INVALID VALUE! Entered data was invalid. Enter data in a valid range.LACK OF CAPACITY! The recording capacity on the P2 card isinsufficient.Insert a card with sufficient recordingcapacity.MISSING CLIP!You tried to add a shot mark to a clip that hadbeen recorded across multiple cards, usinganother 3D device.Any clip recorded across multiple cards isnot supported.NO CARD! No P2 or SD card is inserted. Insert compatible media.NO FILE! The designated file is not found. Check the file.NO SD CARD! No SD card is inserted. Insert an SD card.TOO MANY CLIPS! Too many clips are selected. Reduce the number of selected clips.UNKNOWNCONTENTS FORMAT!P2 card contains contents versionmismatches or corrupted content.• Match devices and contents versions.• If corrupted clips exist (includingcorrupted clips that are located on thecopy destination), repair the corruptedclips or delete them.UNKNOWN DATA! The metadata character code is invalid.Use UTF-8 for the metadata charactercode. Use the viewer to enter correctcharacters.USER CLIP NAMEMODIFIED!Characters in the clip name had to bedeleted in adding the counter value.The user clip name plus the countervalue can only contain up to 100bytes. Characters in the clip name areautomatically deleted when the totalexceeds 100 bytes.WRITE PROTECTED! The P2 or SD card is write protected. Insert write-enabled media.SoftkeyboardCANNOT SET! INVALIDVALUE! The entered value is incorrect. Change the value.
