10Chapter MenuOperationsItem Setting NotesTIME ZONE Sets the time difference relative to Greenwich MeanTime (GMT).–12:00 ... 0:00 ... +13:00For details, see [Setting Date and Time of InternalClock] (page 28).• This setting cannot be initialized byperforming the MENU INIT option andthe INITIAL option in USER FILE.H PHASE Adjusts the horizontal phase when phase is locked tothe signal input to the GENLOCK IN connector.–512 ... 0 ... +511• Hold down the JOG dial button andturn it downwards or upwards andmaintain this position to quicklychange values.GENLOCK SEL Selects the GENLOCK input.GENLOCK IN: Signal input to the GENLOCK INconnector (HD Tri-level sync)RETURN IN: Signal input to the RETURN IN connector(HD SDI)MENU INIT Restores all setting menu values including all scenefiles 1 – 6 and the user file to their factory defaults.• The TIME ZONE setting does notreturn to its factory default.DIAGNOSTIC ScreenItem Setting NotesVERSION Indicates the version of the firmware used in thiscamera.A subscreen provides details on which firmwareversions are used.(Subscreen)CAM SOFT: Software of the camera microprocessorSYSCON SOFT: Software of the system controlmicroprocessorP2CS BL2-1: Boot program 1 of the P2 controlmicroprocessorP2CS BL2-2: Boot program 2 of the P2 controlmicroprocessorP2CS KR: Kernel of the P2 control microprocessorP2CS AP: Application software of the P2 controlmicroprocessorVUP: Software of the system that totally updates thefirmware of this productVUP FS: File system for updating this productCAM FPGA: Configuration ROM of the camera FPGACAMIO FPGA: Configuration ROM of the camera IOFPGAAVIO FPGA: Configuration ROM of the AVIO FPGAPQCONT FPGA: Configuration ROM of the PQ controlFPGAMODEL NAME Indicates the model name of this camera.SERIAL NO. Indicates serial number of this camera. (xxxxxxxxxx)OPERATION Indicates the time of the camera has been on. (xxxx h)OPTION MENU ScreenOpen this menu by holding down the DISP/MODE CHK button and when shooting status appears press the front MENUbutton.Item Setting NotesAREA SELECT Selects the TV system for the area where you use thecamera.NTSC: Selects the NTSC area.PAL: Selects the PAL area.____ indicates the factory setting
