12.3 [10-3] DDI / DID TableIncoming trunk calls with DDI/DID numbers can be distributed to specific destinations. Each DDI/DID numberhas a destination programmed for each time mode (day/lunch/break/night).When CLI distribution is enabled for a DDI/DID number, incoming trunk calls with that DDI/DID number will bedistributed to the CLI destinations (instead of the DDI/DID destinations) if the caller’s identification number isfound in the System Speed Dialling Table, which is used as the Caller ID Table. CLI distribution can be enabledor disabled for each time mode (day/lunch/break/night) on a DDI/DID number basis.A maximum of 1000 DDI/DID numbers can be programmed with other related parameters. 100 numbers aredisplayed at a time. To display other sets of numbers, click the applicable tab.To assign DDI/DID destination numbers, enter directly or click Destination Setting (see 2.1.6 ExtensionNumber Setting). It is possible to programme DDI/DID numbers and DDI/DID destinations in each time mode(day/lunch/break/night) for a set of locations in series at once by clicking Automatic Registration, or toprogramme DDI/DID names for a set of locations in series at once by clicking Name Generate.DDI / DID NumberSpecifies the DDI/DID number.Value RangeMax. 32 digits (consisting of 0–9, *, and #)Maintenance Console Location12.3 [10-3] DDI / DID TableProgramming Manual References12.4 [10-3] DDI/DID Table—Automatic RegistrationFeature Guide References1.1.1.3 Direct Inward Dialling (DID)/Direct Dialling In (DDI)DDI / DID NameSpecifies the name for the DDI/DID number which is shown on the extension’s display when receiving a callwith the DDI/DID number. The name of the DDI/DID number can be printed out on SMDR.Value RangeMax. 20 charactersMaintenance Console Location12.3 [10-3] DDI / DID TableProgramming Manual References12.5 [10-3] DDI/DID Table—Name Generate13.1 [11-1] Main—SMDR Options— SMDR Options—DDI/DID Number & NamePC Programming Manual 82112.3 [10-3] DDI / DID Table
