11.2 [9-2] Network Data TransmissionSettings related to the transmission of extension BLF (Busy Line Field) data or Message Waiting notificationsover a network of PBXs can be programmed.Extension BLF data is used to show the status of a monitored extension attached to another PBX on a NetworkDSS (NDSS) button. Network Message Waiting notifications are used for the Centralised VM feature, and aVPS can send notifications to extensions connected to any PBX in the network.Network Data Transmission for Centralised Operator Feature—Network PBX IDSpecifies the Network ID of the PBX, for Network Direct Station Selection (NDSS). This parameter must beset in correspondence with the Network IDs assigned to other PBXs in the network.Network IDs 1-8 can only be assigned to one PBX each within a network. Assigning the same Network ID totwo PBXs will cause network data transmission problems.Changing this value in Interactive mode will automatically clear any NDSS Link Data.Value Range0: The PBX retransmits BLF data sent by other PBXs.1: The PBX receives BLF data sent by other PBXs.2–8: The PBX transmits BLF data over the network.Maintenance Console Location11.2 [9-2] Network Data TransmissionProgramming Manual ReferencesNoneFeature Guide References1.30.5.1 Network Direct Station Selection (NDSS)Network Data Transmission for Centralised Operator Feature—DataTransmission VoIP->ISDNSelects whether to re-send BLF data received from a VoIP port through any ISDN ports that are set to transmitBLF data.Value RangeDisable, EnableMaintenance Console Location11.2 [9-2] Network Data TransmissionProgramming Manual References3.14 [1-1] Slot—Port Property - BRI Port—ISDN CO— Networking Data Transfer3.16 [1-1] Slot—Port Property - PRI Port (KX-TDA100/KX-TDA200/KX-TDA600 only)—CO Setting—Networking Data TransferPC Programming Manual 79911.2 [9-2] Network Data Transmission
