Panasonic KX-TDA100 Programming Manual

Also see for HYBRID IP-PBX KX-TDA100: User guide User guide Technical information Technical information Features guide

Contents

Panasonic KX-TDA100 Programming Manual Manual pdf 310 page image

3.33 [1-1] Slot—Card Property - IP GatewayThe properties of the VoIP Gateway card can be specified.En-bloc Dialling settingSelects the call dialling mode.Value RangeEn-bloc: The PBX sends all of the dialled digits at once after the extension user completes dialling. The PBXrecognises the end of dialling when (1) # is dialled, if programmed, (2) a preprogrammed telephone numberis dialled, or (3) the inter-digit timer expires.Overlap: The PBX sends dialled digits one at a time.Maintenance Console Location3.33 [1-1] Slot—Card Property - IP GatewayProgramming Manual References4.4 [2-3] Timers & Counters—Dial / IRNA / Recall / Tone— Dial—Extension Inter-digit4.17 [2-9] System Options—Option 2— ISDN en Bloc Dial—[#] as End of Dial for en Bloc mode5.4 [3-1-4] Dialling PlanFeature Guide References1.30.2 Voice over Internet Protocol (VoIP) NetworkQSIG-CTEnables a call to be transferred to a destination extension at another PBX in a QSIG network.Value RangeYes, NoMaintenance Console Location3.33 [1-1] Slot—Card Property - IP GatewayProgramming Manual ReferencesNoneFeature Guide References1.30.4.4 Call Transfer (CT)—by QSIGQSIG-CFEnables a call to be forwarded to a destination extension at another PBX in a QSIG network.When using the Centralised VM feature, set this to "No".310 PC Programming Manual3.33 [1-1] Slot—Card Property - IP Gateway